Routing

    Port Forwarding allows only 10 entries, I need 5 more, how can I add those to a Cisco RVS4000 Gigabit Router.              

Hello,I know that the reason for making VLAN's is to create different networks and BROADCAST DOMAINS but .....At one of our customers some IT guy has put everithing that go over wire CAT 5 cable on VLAN 1 and everithing on Wireless is on VLAN 10.LAN ...

I am trying out a new QOS map and ran into dropped packets on our second site. The first site I implemented this on is working with no packet loss. The second site has two routers and both are randomly dropping packets. All sites are running Cisco 39...

Hey guys, I'm new at this but the company I work for now is asking me to set up a redundant/failover network for them. At the moment we have two (2) 2811 routers and two (2) ISPs. These connect to a 3560 switch before connecting to our domain server....

Hi. I have cisco router 2911 (Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.2(3)T, RELEASE SOFTWARE (fc1)In local nework i have public DNS server with our domain,On the cisco router i haveip nat inside source static tcp 192.168...

Morning,I am currently working on a client site where the client has rural branches. I would really appreciate suggestions for connectivity solutions as the client feels VSAT and fibre (of course microwave access from the last POP for certain areas) ...

Peace.I'm trying to do vpn between two routers.The first router model 1841His dial settings is like this:crypto isakmp policy 1encr aes authentication pre-sharegroup 2  !  crypto map hakim_to_yoni 10 ipsec-isakmp set peer 81.218.161.32set transform-s...

During an installation, we plugged a Ruckus wireless bridge (powered by a PoE injector) into G0/0 on the 1941.  The port status remained down/down.  We then tried connecting it to G0/1.  Again, the port status remained down/down.  We took another wir...

Hi Expert,I am going to implement ipv6 nat-pt in production network. But before doing that I am working on LAB environment. But facing some problems. On cisco router IOS ver 12.4 I configured ipv6 nat shown as below:!version 12.4service timestamps de...

Hi,I have a cisco 1801 router that is not prompting for enable password.After loging into router thru telnet it puts direct into privelege mode without promting for enable password.Here is the configuration:User Access VerificationUsername: adminPass...