Routing

Hi,The below output has taken from cisco 3750 switch which the cpu utilization is more than 80%. Can anybody help what is the meaning of this below inforamation.switch#debug platform cpu-queues icmp-qdebug platform cpu-queue icmp-q debugging is onFe...

Hi Expert,i'm doubt when replace the VSS sup card on standby swtch (sw#1) and manual switchover from active switch (sw#2) to sw#1. I got DHCP delay response 20 minutes to IP phone. I don't understand why? Actually, the phone should be operated and sh...

Hi friendz,We have one point to point link of 10MBPS. when ever there is an outage with the ISP with the fiber outage,  line protocol of the physical interface is not going down. it will be up always, because of its state up,  traffic will not switch...

Hi all,I need some clarification about the following point. Let's consider a Bidirectional PIM deployment and, more specifically, a shared tree branch without receivers, that is a branch to which only multicast sources are attached. Will there be (*,...

I want to check how BGP connection is built between peers.so first I write below two commands for one of peer Router bgp 1Neighbor 192.168.12.2 remote-as 1I see some information from debug output at once*Mar 1 00:17:49.447: BGP: 192.168.12.2 went fro...

Have customer that we need 3G at new location.  Their company is an AT&T customer.So we have got from distribution a 881G and it has a PCEX-3G-HSPA-US card with it.What do you do or need to get AT&T service on this card.  You call AT&T they don't kno...

Hi Guys,hope this finds you all well.I have a 3845 Router with three connected interfaces, one to my WAN, one to my LAN and another to my wifi zone. I want to limit the amount of WAN bandwidth the WIFI zone can take to say a max of one third and not ...

Looking to run a LAN E to a replication site that is approx 400km's away.Looking for approx #'s I can expect with regards to useable bandwidth across the link.Can I expect to get 50 percent of that 100Mbps ?? Is it lower or higher ?Any help would be ...

Hi dear,I have attached setup like this  :-This is the same scenarioa as ASA with Dual WAN setup. But my requirement is different. I have added in ASA and configure sla is asa, all working fine. When one link goes down traffic passs through backup ro...

Hi I have some scenario to provide network for my cutomerI have 2 Cisco 877 routers and I need one set to bridge mode and one is gateway internetHow do I do?                                          (LAN)                 ADSL <---------------->877 <-...

Hi all, hope I'm not being too much of a bother I have the following setup on my router after running sh run:Interface Ethernet0ip address 196.43.102.46 255.255.255.248Interface serial0ip address 216.104.193.198 255.255.255.252no ip redirectsno ip ...

HelloI need  some advices please send me your feeds..I have MSTP mesh topology and and I want to izolate  two switches which connects to provider side I mean when MSTP calculating I don't want it dissconect or reset links that connected to ISP side b...

Hi Everyone,I'm newbie in Cisco device thats why i have confussion in my layout network design if this device working properly if i put this to my netwok. i want to config my router with 3 different subnet and in switch area i want to create 3 vlans ...