Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, I am not able to establish RIP routing between Two routers. Mattise and Dali. Both Router are able to communicate but RIP routes are not able to exchange. Attached is the configuration of both Routers.I want to exchange RIP Routes between these r...

I need to configure BGP on our 7204 and 2811 router.  The 7204 is our main router and currently running EIGRP internally.  Our remote locations just moved to an MPLS connectivity and they have a 2811 router.  I will need to configure BGP for the rout...

dacruzer1 by Level 1
  • 820 Views
  • 4 replies
  • 0 Helpful votes

I need to understand the difference on below commands-Peer-config-check-bypassReload restore or Auto recovery  Also I have below doubts-•-          I have 2 Nexus boxes(connected using peer links and keep alive link) running on production. If I put ‘...

govind346 by Level 1
  • 1632 Views
  • 5 replies
  • 0 Helpful votes

We have a 7206VXR with an NPE-G1 processor. We're running the standard stuff on it, but here are the highlights:eigrpipsec tunnels (approx 45)netflowqosextended ACLsbgp (1 neighbor)We just enabled netflow on it to send the data to an external source ...

aweise by Level 1
  • 909 Views
  • 4 replies
  • 0 Helpful votes

Hello community,since a some period of time my edge router (cisco7200 with NPE-2G) has a massive performance problem causing by BGP process.rc-e100-49-69#sh processes cpu sorted | i BGP 204  1224991632 222733885       5499 14.07% 10.89% 10.71%   0 BG...

Hi, I'm trying to manipulate traffic for my WAN. Basically, I'm trying to stop traffic for a particular /24 block from coming in via Link 1 and instead come in via Link 2 and 3.after adding "ip prefix-list asprepend seq 25 permit 1.1.169.0/24" into o...

I have a 3825 with fan 3 failing according to syslog messages.ENVMON-4-FAN_LOW_RPM: Fan 3 service recommended I have taken the router a part and see that fan 3 is slimmer than fans 1 and 2. I am trying to find a replacement fan, but only can find fan...

Setup:Site A Cisco 2911 -- 2 T1 WIC.  One going to Site B 1841 another going to Site C 1841.I am looking for a way to setup a Polycom QOS, judging by several forum posts about this, would it be better to create an access list with the Polycom IPs to ...

I am trying to troubleshoot a QOS problem on a Sprint MPLS connection.  I currently have two 50Mb ethernet circuits from the CE router to Sprint's PE router at two locations.  I get choppy video calls between these locations and the only way I can re...

altafmir by Level 1
  • 1710 Views
  • 11 replies
  • 0 Helpful votes

I've been trying to crack this one for a while but I can't see the wood for the trees. This router feeds a Sonicwall security device at 192.168.0.180 on the inside and performs ADSL2+ on the outside. I can do domain lookups on the internal lan (the o...