Routing

Hi All,I have two locations as shown in the attached figure. Now the locations are connected with MPLS link and its working fine. I want to use the available VPN link as the secondary one. IPSec tunnel has been configured between V1 and V2 using the ...

Hi,we have been having issue with getting bgp session up with our ISP. The problem starts when we enable MD5 auth for BGP it does not come up and stays in Active state, as soon as we remove the password the session is up and running.The MD5 auth for ...

Hi guys,Have some questions regarding NTP. I have two routers, one is synched the other will not to the same server.  Both routers have the same static routes configured.Also I have four NTP servers listed and only one appears sane. I have put the ou...

I am trying to configure cisco 3800 as NTP server for all Juniper MX router clientsPerpose is to server the clock to all Juniper routers.But i m facing weird issue.. All Juniper routers are getting synch with Cisco 3800 but there is difference of 30 ...

I have two datacenters with two leased fibers running between them.  Currently one datacenter is just a slave off the main site with layer 3 switches connected by OSPF to routed interfaces.  The fibers themselves hook up to stacked 3750gs one each si...

Can anyone help me understand how this might work? I’m having serious issues getting Tandberg H.323 working behind this router with NAT. My setup is Cisco 1811 configured with Fas0 to pull DHCP (public address). This router is being used in a mobile ...

Hi,Does anybody know what cable is needed to for this module?Any halp is much appreciated.

Ok, so I have the VWIC-2MFT-T1 installed in a router with 2 data T-1s no voice - kind of a waste I know. The one port is taking incrementing input errors - while the other one is working without problem. I have replaced the cable. I have contacted th...

I need to create a policy to provide only 4 Mbps bandwidth for mail out of 16 mbps pipe terminated on 7606 router (at Datacenter) having  WS-SUP32-GE-3B.But I can't create policy with the help of bandwidth percent,even exact value with priority comma...

Hi All,Can somebody explain me in deep the following ACL.access-list 101 permit ip 193.78.0.0 0.0.255.255 255.255.0.0 0.0.0.0Especially the underline part and how it affects.PS: I have marked this as discussion and not as question, because i don't kn...

HiI try to configure a cisco router to set up a failover between ADSL and ISDN lines. The ISDN line only works if I call at the right dialer. ADSL line also works if I call the associated dialer The problem is that automatically switches between ISDN...