Routing

Hi,I have MGX 8850 (PXM45/AXSM) and I want replace My faulty hard disk 40Gbps (4200RPM) whith other hard disk 80Gbps (5200RPM).Is it possible or No?Thank you for your help.

Hi,        I am new to networking. I want  use GNS3 to configure routers but i dont know from where to get the ios for all the routers available in the list present in GNS3.  I need tips on configuring routers too.  Pls let me know if there is any vi...

Hi ALL,Router(config)#logging facility local6 - what does local6 mean?.When i referred to the cisco site i found that Reserved for locally defined messages.But i don't it means Reserved for locally defined messages .Can anybody give me the exact expl...

HiI have an issue with IPSec tunnel where the tunnel is changing status to UP-NO-IKE upon sending any traffic.After clearing crypto session through command, it again shows UP  and then went into UP-NO-IKE state and could not route any traffic further...

Have issued login on-failure log and login on success log commands, however only the on-success works and puts output into log, the on-failure command does nothing.If I issue the additional command login block-for this causes the on-failure to work, ...

The classes I am creating have to be in a specific order within the policy.  Is there anyway to re-order the classes within a policy map without delete the entire policy and re-applying?

i have two routers attach for a tunnel. in both router i have configured a same area and i detected in bot router logs of:%CLNS-3-BADPACKET: ISIS: L1 LSP, bad max-area-addresses 0, ID 0100.6400.0034.00-00, seq 85, ht 0 from 0018.7425.6500 (GigabitEth...

We are having 2 Cisco 3560G switches where 3 Vlans are configured and among these Vlans HSRP is there for redundancy.In between these Cisco 3560G there is L2 Etherchannel and we haven't observe any Error messages on this Trunk.We are getting HSRP Sta...

Hi,Running around 100 OSPF adjacencies on a single router CISCO2911/K9, and intend to add a further 100-200 on top of this. Is there a restriction to the number permitted/recommended? The router is acting as a single core node in OSPF Area 10, with u...

Hello,I have tried several IOS images and finally found that the Service Provider image (c1841-spservicesk9-mz.124-24.T5.bin) finally seesthe cable modem HWIC, but i constantly get RBCP errors and Comcast can not see the router, nor can I see the com...

Hi folks,I'm stuck with some NAT issues. I've got an 800-series router wich connects to the internet via a PPP connection (dialer0).On the inside the router has 192.168.0.253/24 as IP address, the outside is negotiated with the ISPMy mailserver has t...