Routing

Where can I find more information on the firewall portion of the 2951 ISR gen2 ?I am having issues with dropped passive FTP traffic. I can initiate a session, begin a transfer then it fails.On the recieving FTP server or PC end you can see that a fil...

I have a 2600 router on the edge of my network...connected to a DSL line...dnyamic IP handeled by DYNDNS service.I am running a Windows 2003 server with Exchange 2003 on it...I have the following lines in my config file :ip nat inside source static t...

Q:cannot ping direct connection interface. "show cdp" can see the nei up. What steps  can be taken to troubleshoot the issue.configuration on interface:!interface GigabitEthernet0/0  ip address 1.1.1.1 255.255.255.252 no ip redirects no ip directed-b...

Dear all,I have 30 branch all over the country.There we have Cisco 3825 Series router at HO, and 892/k9m 1841 and 1811 routers in BO.My branches are being connected to HO via dual link which has been linked with two ISPs,both are Layer 2 link provide...

Hello everybody,I posted this query in 'AAA' secition but no answers.. so posting here for quick answer ;-).Trying to figure out if there is any major difference between..1. enabling 'aaa' with local database authentication !aaa new-modelusername use...

Hello,I have a question regarding the redistribution of EIGRP routes into IS-IS.I have to connect 2 networks, one is using EIGRP as routing protocol, the other one IS-IS.This is the (simplified) setup.network 192.168.1.0/24 --- Router #1 (EIGRP) ----...

Hi,I have two WS-C2950G-24-EI switches each of which were running software version 12.1(22)EA2-C2950-I6Q4L2-M.  Both swtiches were viewable from Network Assistant version 5.6(3) and part of a community.  I then updated the software on one of the swit...

Hi Folks,I have in production a 2811 ISR which works just fine.  Also in production I have a small NetGear wireless router hooked into it providing wireless access to my local network and internet for any of my traveling sales people and laptops.  I ...

Hi, does anybody know why aaa accounting commands supports only tacacs as destination and not radius ??UBR10k(config)#aaa accounting commands 0 default stop-only group radius-authUBR10k(config)#.Jun 24 08:59:05.009: %AAAA-4-SERVNOTACPLUS: The server-...

HiI want to create a redundant ring topology.Switch A <-> Switch BSwitch B <-> Switch CSwitch C <-> Switch AI`m using gigabit interfaces, and want 2Gbps backbone capasaty.What will be the best setup here?Thought about using LACP and RSTP, but can the...

HiI run a small WISP, and now expanding to also connect some customers via fiber.They will get public IPs via DHCP.Planning on using ISC DHCP, and option 82, to protect against dhcp starvation attack.Managed CPE will take care of rate limit.But what ...

Is there any way to make cisco ios decide its behaviourie... i have a remote site called a.com (internet) and b.com (internet).The scenario is if { A-->down}    (route it via link-b) else   ( route it via A) such type of if else is critical in todays...