Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Can I delete the running IOS from flash on an operational 3845 router to make room for the newer version?  The flash isn't large enough to hold two versions.  Doesn't the IOS get loaded and run from NVRAM?  I don't want to take down an operational ro...

johartman by Level 1
  • 546 Views
  • 3 replies
  • 0 Helpful votes

Hi,     Does anyone use this feature?I have seen the document on CCO explaining how to turn it on/off, but was looking for some guidelines to using it.So please don't point me to that doc!ThanksColin

c.walsh by Level 3
  • 2915 Views
  • 1 replies
  • 0 Helpful votes

Resolved! WIC-1T and E1

Recently we want to connect Internet link of Bandwidth 2M at one of the locations. It has WIC-1T module currently catering to 1M.We have placed order with X.21 interface  and 2M bandwidth. Our implementation team said that this is the E1 and it canno...

Resolved! VPN

Hello,This is our EzVPN Router config, show crypto isakmp indicates Tunnel  Established but cannot ping any host behind the router to any server  behind the other end.Server IP at other end : 192.168.1.100/24crypto isakmp policy 10 hash md5 authentic...

dear allcan anyone please guide me how can i control my bandwidth for each subnet which is behind the router. means i have got multiple client having their own subnets connected to a single router on FE0/1 and they are connected to wan via public IP ...

HiI have two T1s in a Multilink 1 groupand having issues with the bundle name not always being the same and thus causing only one T1 to be able to join the bundledebugging -------------------------1w5d: Se1/0:0 MLP: Link not added to bundle1w5d: Se1/...

fprime7 by Level 1
  • 1713 Views
  • 9 replies
  • 0 Helpful votes

Hi guys. I'm getting ready to implement VOIP on our LAN. I will have a PRI gateway that takes calls out to the PSTN, so I do not need to worry about WAN issues. I am going to be using non-Cisco, SIP phones, and I will have two VLAN's setup - the n...

Dear Experts & friends,This is a HA related query and I am expecting you to share your experience here and help me. A same thread i started some months ago, but couldnt continue. I am starting it again. Mr.Jon Marshall helped me, but I missed to cont...

Hi,  I am trying to configure below commands in Cisco 4506 E with SUP 6 LE but these commands are not not supporting in the switch.Even QOS command is not taking in the siwtch....This was working fine in Cisco 4500 with SUP 2..not i upgared to 4506 E...

Hi, all, hopefully this is a simple question, but I am stuck ... I am implementing mGRE with DMVPN so multicast traffic can be delivered to employee homes over Internet, everything worked fine except that I can not configure PIM or ICMP static groups...