Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Bookmark
|
Subscribe
|
Labels

Forum Posts

Start a conversation

Resolved! QoS question

If i have the following statementClass-map match-all xxx1Match protocol httpClass-map match-all xxx2Match protocol http host xxx.xxx.xxx.xxxpolicy-map xxx   class xxx1       set dscp af11   class xxx2       set dscp af12within this statement once htt...

Resolved! HSRP simple question

HelloPlease see the attached diagram.Router 1 is in a different building to Router 2.  There is dynamic routing information passed between all routers.Is there any reason to setup HSRP between Router 1 and Router 2?And is it possible given that all i...

Resolved! BGP behavior on AT&T T1 MPLS AS

We are in the process of deploying Cisco 2901's running IOS 15.0 to several locations across the United States.  Each of these routers is connected to its own AT&T T1 circuit via VWIC2-1MFT-T1/E1 cards.  Our head office has 4 trunked T1 circuits @ 6....

wayfaring by • Level 1
  • 3192 Views
  • 2 replies
  • 0 Helpful votes

Data Recovery/Failover over P-T-P WAN

Hopefully I am wording this decent enough to understand.  I am working in a team where we are deploying VMware for a business that has two locations that are connected via a point-to-point wan connection.  At each end of that connection they have Cis...

FRAME RELAY COMMAND ON 7600

HI,I need your help. We have a issue with a 7606-S router and frame relay traffic shaping command.the command frame-relay traffic-shaping is not available, when i want to configure it on a serial interface.I have the following equipment:RSP720CXL-RIO...

tona_2008 by • Level 1
  • 449 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Route map issue

As per attached diagram,      I have two isp and two core switch with 10 vlans and two core switch interconnected with cascading.  One vlan i put Bluecoat and we are using proxy.I need to block all internet traffic without proxy.  I mean any internet...

Qos Router Cisco With Firewall Fortigate

I have qos in 4 router cisco  connected by metroethernet, and i have one firewall connected in the same metroethernet.The config in router cisco is:policy-map QoS class Trafico-Voz-Out  priority 1000  set cos 5 class Signaling-Voz-Out  bandwidth 96  ...

Resolved! Enable pinging WAN IP from ethernet clients

HelloI'm trying to enable access to web servers and other things from the lan using the WAN IP,Currently pinging the wan ip does not reply.  External access to the resources is working correctly.any help would be really appreciated. Thanks

GovanJ221 by • Level 1
  • 1284 Views
  • 5 replies
  • 0 Helpful votes

EIGRP question

In the pic you'll see the Eigrp link with 170 and the DMVPN link which is being seen as 90 (internal)The problem I'm having is that when anyone wants to reach 10.69.0.0 /26 they're going through the DMVPN because that path is being seen as 90 where t...

Resolved! MPLS

Hi 2 AllI got little idea about MPLS and routing. Can someone help me to find solution to my concern.We got Two DataCenter and 65 small regional sites.DC1 connects to DC2 via Fiber and backup link 10MB with Broadband.In order to have remote branch co...

VLSM

Dear all,I have a problem in understanding with VLSM, In theory, VLSM is not supported by by RIPv1, If I want to have a practice in real scenario what should i do? I tried it with 2 subnets in a router 192.168.10.0/29 and 192.168.10.96/28 I think it ...

Tag or untagged on Fastethernet interface

HI all,We are planning to connect to a VPLS provider for our WAN Connectivity.The provider is asking us to tag the traffic on the interface going to the VPLS.We are planning using EIGRP, testing phases are running OK with the subinterface being tagge...

Load more
Top