Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi thereThe customer saw the RADIUS replies have a size of 1423 bytes.However, the RADIUS server  can not reach the remote WIFI controller  with MTU above 1344 bytes.The RADIUS request has a size of 423 which goes through. So the server sends a packe...

Hi All,I have a router 1841 connected with ADSL and behind this router connected ASA5520 with private IP Adresse.the router ADSL is configured with vpn site-to-site with 3 sites:i want to configure vpn remote client with ASA5520,to do this i want to ...

Hi all!I have a Cisco CISCO2901/K9 router which I'm using as a Internet gateway.The question: Is there any possibilities to control / shape the inbound traffic, so that I can reserve an amount of the bandwidth for a single VLAN?I'm using a streaming ...

Hi,If we configure GRE tunnel between over the network which is not Multicasting enabled. But we need to send multicasting packets over GRE tunnel.If we run routing protocol on the GRE tunnel it will form the neighbor relationship. Will it encapsulat...

Hello.I've been looking a lot, both at google and on this forum, but I can not find the solution. I can not configure a router 836 on a ADSL over ISDN line .The company is Jaztel ISP, PVC 8 / 35 PPPOE.The CD Led is on, but the PPP not.Thank you.Regar...

Hi,I have a Cisco 857 router. I have an internal ip address to which I want to direct traffic from an external source.The internal IP address is 192.168.2.50. Previously I have translated a single port to this address, I did this by adding a line to ...

nickc1976 by Level 1
  • 8496 Views
  • 5 replies
  • 0 Helpful votes

Config in Cisco3845 IOS c3845-advipservicesk9-mz.124-24.T2.bin:policy-map child class TOS1    bandwidth percent 45policy-map parent class class-default    shape average 2000000  service-policy childinterface Tunnel1201 bandwidth 300 tunnel bandwidth ...

georgd by Level 1
  • 1980 Views
  • 5 replies
  • 0 Helpful votes

I have an ASA 5505 firewall configured as an IPSec VPN gateway which a direct public IP is assigned to the outside WAN interface. After a while I can't access any outside IPs from the firewall even the gateway of the public IP. When I remove the IP a...

Resolved! QOS

HiBranch_Office connects to HQ using service_provider MPLS network.In order to improve Voice Quality between branches and HQ, QOS is needed.Can someone help with steps needed to configure QOS at HQ and branch end.

We get some HighQueueDropRate Alerts from Cisco works on our 2600 Routers with T1 links.These look to come from both Fa and Se ports of the routers.What could be causing these alerts?  Or are the thresholds set to low?Here is an example of the alert....

fasteddye by Level 1
  • 657 Views
  • 0 replies
  • 0 Helpful votes