Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have Cat 3560-E switch the I'm upgrading from the twingig ports to the 10gig ports. When the switch boots up the ports go into err-disable. I haven't had much luck finding any docx on this.  I don't have the fiber to connect it up yet so I'm wonder...

Hi guys,Thanks for all the help thus far and I am nearing completion of my project.  I have one last piece to finish.I hooked the asa to a wan port, got my routing set and I am havng this problem.1. With NAT enabled on that wan port of the router, I ...

bhicks by Level 1
  • 1123 Views
  • 4 replies
  • 0 Helpful votes

HiI am testing these new ISR G2 routers but now my problem is, on the ISR G2 I don't get the option to set up the protocol to PPPoE under the vpdn group name configuration instead there's only protocol l2tp. Previously I have tested an 877W for PPPoE...

Hello,I have been working on a network topology design for one of my clients.  Please see the attached pdf detailing the diagram and traffic flow scenarios.The routers have a 4 port switch module that connects to Switches A Primary and B Secondary.  ...

Cody Ridge by Level 1
  • 2136 Views
  • 12 replies
  • 0 Helpful votes

Is there anyway to have a V35 connectivity between equipments that is more than 32 feet distance?Each Cisco CAB-SS-V35MT is only 10 feet long; with one end as IAD serial port, and the other end as V35.Even if we interlink the each CAB-V35MT and each ...

Hi All,I am not able to configure the neighbor ip-address as-override command on my cisco 2821 router.My router ios - c2800nm-advsecurityk9-mz.124-15.T9.bin.What should I do for that command to work on my router?

sir we have to internet connectivity and each ip address segment from  from each isp. to acces our internal server we are giving static nat IP in both the segment so that if one link goes down the client can access through anothe link.we need to chan...

Hi ,We are keep getting the following error on our Cisco 6509-E VSL pair.We have replaced SUP720 and also few moudles, but the error is still appering once or  twice a day. We do have outage on our network due to high cpu on VSL pair.Any idea?Regards...

Hello,Does anyone know of an inexpensive way to force a user to a web page where they have to put in a password in order to get out to the Internet?  The equipment in place would be a bunch of 1230 APs and a 2621XM router.  The router can be upgraded...

Good Day,Our network serves a residence hall on a university campus. At present we have 7 100mbps links (and 7 subnets), to the router on campus to serve, on average 350 concurrent users. For budgetary reasons we are considering going with a private ...

ihouse205 by Level 1
  • 452 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card