Routing

I wonder if in Configuration Exercise 5 of Chapter 5 (RIP) RTB can route packets correctly.For example, a packet with IP destination address 192.168.20.152, the last byte is 10011000,has the first 5 bits of the last byte 10011. In RTB's route table w...

The "lost carrier" counter is periodically incrementing on a gigabit interface (sh int) connected to a service providers equipment. Documentation indicates this counter increments based on the "interface detection link" mechanism, but I can find no ...

Is it possible to place the start-up configuration file on 2811 router on the flash?What I am trying to accomplish is add the configuration on the flash in my office and ship it to a remote location where a brand new 2811 router is located. In order...

Hi,If IOS supports route-refresh capability then can i do away with soft-reconfiguration inbound to save memory and cpu utilization in multi-vrf ce routers.ThanksKas

if there is a need to lower/adjust the bgp convergence time,what would be the ideal time for this & how is it decided. We'r talking about roughly 80 routes across the network.Thanks!

I have a PC directly connected to my router interface, I want to secure the interface so that when other device connects to the interface it shut down... just like port security of a switch.... please how do I do this or any related security.

I want to run EoMPLSoGRE between 2 data centers terminating the GRE and pwire on the ASR. Couple of questions: 1) Are there any special requirements on the ASR to support this? 2) Any caveats with running this in this manner?My first hop is L3 with ...

Dear sir,I have a point to multipoint connectivity at arround 80km distance.Which series switches will support HSRP and VRRP on l2 and l3ZX module will support 100Km plz give me the clarity anybody plzsrini

Hi,We have L3 switch with VLAN 10,20, and 30. There are no interfcaes for VLAN 20 and 30 on this L3 switch. But interfces are created with IP addresses. Other L2 switches are connected by trunk to this L3 switch. On L3 switch there are interfaces on...

Hi.A router has two static default routes to internet pointing to two different gateways.I wish to have OSPF redistributing a default-route only to one default gateway: if the interface pointing to it goes down, no default-route has to be redistribut...

hi experts,i can't distinguish between these 2 technologies. can someone enlighten me what is the difference between MPLS and IP-VPN?

Is every where a documented limit for number of endings of a mgre tunnel?Also is a documented maxim number of eigrp adjacencies on this type of interface?(I'm interested on 7200 model)