Routing

I have a 3745 router with one Fa port. I configured two ip ranges on that port and I want to create QOS on the WAN link to guar. 10 megs of traffic. How can i set that up for one ip range? does anyone have any sample configs i can see?

Situation...interface Gi0/1.2 encapsulation dot1Q 2 xconnect 10.0.0.1 1111 encapsulation mplsIs there a way to see the Mac Addresses on that subif???

Dear Experts,I have one 2 PCs in my branch office are connected through WAN link Layer 2 (1MB) to my Headquarters.Although I can Ping and Telnet from the 2 PCs to my Headquarters Network and I can connct through RDP from any PC in my Headquarters to ...

Hi,I was searching for OID of SNR values ( Attenuation and Noise) for Cisco 877M to graph this values. I did a snmpwalk, I was searching in cisco mib but I don't find yet.Do you know the OID for graph this values?Thanks!

Hi,in my lab Back to back with 2801 IOS ver 12.4(24)T1 and two card HWIC-2T the following tests were doing:*when i use the CAB-SS-X21MT and CAB-SS-X21FC cables Result: the highest clock rate that can be supported is 1000000 and lower *when i use CAB-...

Hi,I am maintaining the Bank network,our banks are in 5 countries.The network consists of Cisco 6509 ,4507 R switches and Cisco 3845 Routers,braches are connected through MPLS cloud.Now the bank people are going for the IP TV,for this IP TV to work,w...

hi experts,we have 2 sites connected via BGP on a 10mb bandwidth link. both end can give 18ms average when ping. On our side, is there a way to speed this up? or like LAN? What's a effective and practical way of doing this?tnx

Hi Experts,I have a scenario where my core switch 4500 is connected to a remote location using both Optical fiber cable (primary link) and a leased Line (secondary).Optical Fiber cable is directly connected to remote network (see the attached diagram...

Dears,Topology: Its a Carrier Supporting Carrier Scenario.A------DS/PE--------------CORE/P---------ISP/PE-------P---------ISP/PE------BThe link between Core and ISP is back to back VRF connected via a layer 2 trunk.The ISP is creating a sub-interfac...

I took the "Do I know this already" quiz in Cisco's BSCI Exam Certification Guide, and one of the questions asked me to identify which statements were true about IS-IS. One of them was that all L2 routers must be contiguous, which I selected as true,...

Hi thereI am using HWIC-1GE-SFP on 2811 ISR. the Gig port seems up but cannot ping the other end and does not send any traffic. any help is appreciated.

Hi,I am trying to configure my Cisco 1811 Router as Internet Load Balancer,It has 2 WAN ports and 8 L2 Ports,2 WANs will be using for 2 Internet connection1 L2 port will be using for Internal connectivity,I configured vlan1 for insideOne Internet con...