I am having Cisco 26211 XML router. with 2 inbuilt Ethernet interface and 2 port VIC FXS in NM2v card. I want to install one more Ethernet card in the same router. please provide the part number
I have a Cisco 3640. I was trying to upgrade the image. Is there a way to load the new ios image from rommon? This router has no ip configs. How do you configure ip address, subnet, and default gateway? so i can load from a tftp server.
Hello,I have a point to point network with 4 2620 routers at the hub sites and 1 3640 router at the main site. all of the sudden all of my routers are rebooting automatically with the following error when i do a sh ver:1 - 2620: WASHINGTON uptime is...
Hello everyone,If I have a point to point connection No vlans) with the router on the far side having a FE ip address of 10.10.10.1 and configure DHCP relay on the far side router to point to a windows DHCP server on the near side of the point to poi...
hi, recently my few routers, started throwing FAN errors, and now my Solar winds syslog server is all messed up with those messages,is there any free syslog server available for windows, on which i can filter alerts on basis of some string message me...
Hi I am trying to configure QoS in such a way that I allocate the first 30 percent of my bandwith to voice traffic. The router cannot allow bandwidth and priority configured on the same class, how can I realize the goal of allcating the first 30 perc...
i have query related IGMP in multicasting. does i need to enable IGMP on my router interface connected to LAN???? or it would be activated when i run ip pim sparse command on LAN interface?it will work if i only apply ip pim sparse command on my LAN ...
Policy Based RoutingHi,Just wondering if anyone has come across this issue, we have two separate MPLS connections, both are from the same provider and both links receive the same bgp routes, however we are trying to manipulate the routing so that one...
Hi,on my cisco 2811 with IOS 12.4 (15) XY3 everytime I reboot the router the system enable automatically the debug for dot11 syslog.************dot11: dot11 Syslog debugging is on***************Any idea why?Regards
issue in router, reseting again and again with old IOS.ROM: System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2)BOOTLDR: 7200 Software (C7200-K4P-M), Version 12.0(32)S5, RELEASE SOFTWARE (fc2) cr1.SXB uptime is 2 hours, 13 minutesSystem retur...
what is the different between dlsw circuit and dlsw peer? I had a problem where my dlsw peer is connected but my dlsw circuit is disconnect? what could possible cause this?
can some explain why when a circuit randomly bounces, the circuit comes back, but OSPF does not return. It takes a manual bounce to restore OSPF..Thanks
I wanted to know what cisco routers coudl do the full ipv4 routing table in hardware. Correct me if I am wrong, but I am pretty sure most do it in software.Thanks in advance, the only online datasheet that I could find anything useful on was the Sup...
HI,I have a 2501 router running with c2500-is-l_120-4.bin IOS.And i am running dhcp relay agent so that my local locations will get ip address from central DHCP server.Recently we have changed the DHCP server so it is required to change the helper-ad...
We have set up an MPLS with our telco. Main office is in Idaho, remote branch is in New Mexico. When we try to copy large files across the pipe, we get errors. If I've done an SSH session to the router in the remote office, I randomly lose my conn...
