Routing

Hi there,I need to implement hub-spoke multipoint L2 bridging solution over non-mpls IP only enterprise network. Is there any light VPLs or similar technologies that I can use without implementing full blown MPLS. Is there any way to modify l2tpv3 to...

one of my router line protocol is down....if the WAN speed is mismatch will line protocol goes down???? thanks

I have a Cisco 3550 installed. I'm using IP and MAC access-lists. The IP Access-lists are working like they should. However the MAC Access-list seams to have issues with applications.The mac access-list are setup to allow traffic from a couple of ...

Hi,Please let me know the procedure or configuration details for grouping multiple BRI links to get 384 kbps bandwidth which can be used for Video call.Please help me out!!!Regards,

c2811-1#sho file information nvram:?nvram:IOS-Self-Sig#3201.cer nvram:IOS-Self-Sig#3202.cer nvram:IOS-Self-Sig#3203.cer nvram:ifIndex-tablenvram:private-config nvram:startup-config nvram:underlying-config

Is there a way to setup variable QoS for a traffic flow? I have an 85 Mbps metro-ethernet WAN connection between two sites. One side has a Cisco 3745 router, the other has a Cisco 2821 router. We just recently installed two SANs (one at each site)...

Hi ,I have two sites with 1024k links in UK. The links behaves as if they are rate limitted even though i dont have any rate limitting set on the router. The customer for instance sent a 3meg file from a site locally to the UK site. it went up to ...

Hi All,I'm new to hardware load balancing.The present application we have in production is using apache/mod_jk as loadbalancer... which has capability to manage sticky sessions.I was going thru Cisco hardware loadbalancer configuration but, I'm unabl...

I have ASA 5510. I am letting my outside customers on FTP on my server (port range 49152 65535)Is it possible to limit the number of connections from one particular source address (My customer).Thanks,Manny

I am looking to reduce the monthly cost of dedicated private T1 to remote sites. At each site we have 5 staff users and up to 75 others that we provide internet access to at the building. At each site we have T1 for internet and 1 private T1 for da...

I have a router with lots of virtual interfaces. When one of the interfaces goes down every ospf route in the route table has its lifetime reset to zero.I thought only the changed routes should change not all of them, am I right?What would cause the ...

Can static GRE/IPSec tunnels be configured on the same router that is configured for DMVPN?

Our head office has two GRE+IPSEC Tunnels to our data center. This is a Primary and Backup setup using EIGRP internal. The Head office connects to the spokes over MPLS using BGP. So we have 2way redistribution with filters in place. The spokes us...