Routing

Are 3845 chasis hot swapable? can I replace a 48 port card while the unit is running?

Can someone explain me in detail about bc & be? How does both of them differ in practical scenario?Whats the difference b/w exceed action and violate action?police cir 512000 bc 50000 be 80000 conform-action transmit exceed-action drop vio...

Is there any PPPoA support in the ASR100X series at the moment?If i use the feature navigator it isn't listed but it's mentioned at http://www.builtforbroadband.net/en/US/docs/routers/asr1000/install/guide/chassis/asr1_ov1.htmlRegards,Erik

Hi,I will have a PIX with OS8 installed on it serving default route to the internet. Is it possible to bring up a tunnel on the PIX to a backup network and then advertise that route via EIGRP to a 1750 series router acting as the clients default gat...

Hello,How does the ASA firewall ACL permiting traffic for two cisco 1811 site to site IPSEC? Site A and B connected through IPSec. Site A has a ASA firewall and this firewall only use to connect to an outsource application. If I need to permit acl_...

Hi I have two ISP links. Each arrives on a (CPE) 3640. My Internet subnet is splitted in half with a "prefered path" to one of the router. That insure ingress balancing. Now on the other end I have a Pix.How do I balance the egress traffic ? May I pu...

HiI am geeting the below erros can some one suggeest me on the sameNov 16 17:50:28.163 UTC: %SW_MATM-4-MACFLAP_NOTIF: Host 000a.f394.1f3c in vlan 16 is flapping between port Gi2/0/6 and port Po1Nov 16 18:09:18.119 UTC: %SW_MATM-4-MACFLAP_NOTIF: Host ...

Hi All, We are trying to create a trunk between cisco 3550 and 3745. We are not able to send any traffic other the one specified as native. The module is NM-16ESW on the Router with an IOS 12.4.Please find the interface config on the switch and the r...

Cisco specifies WAN Bandwidth limits for its ISR routers starting from 2 Mbps for the 1841 to 45 Mbps for 3845.What is/are the factor(s) that dictate the maximum WAN bandwidth that can be handled by a Router whereas there is no limit(other than the i...

2621XM-Router hang some time(It was working fine from 4 days)after we have upgraded the internet leased line from 1MB to 4MB.whenever the internet line is getting struck inbetween we need to restart the router OR service providers modem.suggest me th...

hi,i am new to telecom hardware side. i am basically from the telecom software (NGOSS) side. i require to know the hierarchy in which all cisco equipments are interconnected with each other in the access and distribution networks of PSTN,wireless,MPL...