Routing

Please advice!!!!!I have old switch, which is WS-C3548-XL, I can't find any command to change the VPT mode from server to transparent mode.The switch is running "c3500XL-c3h2s-mz-120.5.1-XP.bin"Help!!

We have a DSL network using an ATM aggregation circuit and RFC1483 RBE for distribution to clients. Typically the client uses a DSL modem in bridge mode to a home or SOHO ethernet router. Some of the more sophisticated customers needing VPN or QoS ...

Where can I download firmware for new Cisco products still under warrenty?

We have 5 campuses connected with 10Mb Metro E. We're going to drop a router at each location and turn on OSPF between the routers. We're currently looking at the 2800s. I'd like to encrypt traffic between the routers, so that sensitive data is pr...

I have placed a 2801 router at a competitor/customer site that is involved in a joint project. We have set up a server for them to use as a share drive. I am trying to place a very tight ACL to only give them access to the IP 10.20.200.11. I know it'...

Hi,How to create a bridge mode in router and switch?Regards,

Is there a difference between coding0.0.0.0/0 and 0.0.0.0/32 if acceptingonly the default route from the provider?

I have multiple circuits into a remote site. One of these circuits is a PTP DS3, and the other is a frac DS3 over MPLS. The MPLS connection is running BGP. I have a GRE tunnel configured over the MPLS circuit between 2 - 3845 routers. EIGRP is co...

Hi to all.Maybe someone can suggest me the tunning to do for my problem.I have 2 cisco routers with a 10Mb/s-full duplex WAN connection each.If I do an FTP between from a PC on site 1 to a pc on site 2 I reach 9.8Mb/s.Great!!!!If I transfer the same ...

Hi Fellow Networkers,I am having a doubt regarding use of WRED with shaping..policy-map Mahi class Mahi1 priority percent 30 class Mahi2 bandwidth percent 35 random-detect class Mahi3 bandwidth percent 1 random-detect class class-defaul...

I have seen command to bring any module down in cisco 7206 config # hw-module slot number shutdowncan someone pls tell me whats the command to bring it up.

I have an ATM network based on LS1010switches and 7206 routers. The interface speed is usually 155Mbps and normally has several PVC's configured across each interface. My question is how do I decide what bandwidth figures I give to each PVC (sustaine...

Hello,I configured a Cisco 1841 fpr PPPoE via Multilink PPP. I try to set the command"pppoe enable group global"for the FastEthernet0/0 and FastEthernet0/1 interfaces. But this command is not accepted, only "pppoe enable" is possible. Is there a big ...

Good Evening,I am having failed ARP requests over a bridged frame relay circuit. Debugging ARP returns a message similar to: "IP ARP rep filtered .......wrong cable." The end node connected via the WIC card is a member of the bridge group. For bridge...