Routing

Experts,Can any one let me know how to configure CISCO Load Balancing to my SAP Landscape.We have implemented SAP Enterprise Portal,We want to buy CISCO Product for Load Balancing,Can any one suggest me?

hi,There is any possiblity to Configure two DHCP server(in router)in the same network as one as backup

Is it possible to get an external ip-address on the wan interface of the asa, and let the router do the pppoa athentication. Even when the ISP has given you only one external ip-adres...? If yes how should the config looklike.Thnx

Hican I reserve bandwitdh (or percentage of bandwidth) on the link were I'm doing EIGRP neighborship to be used only for EIGRP updates ?Do you have a link on cisco.com ?tksRic

Dear all,My company WAN connected is using Metro Ethernet 3M for each subinterface.I want to clarify four points, 1. Fa1/1 using speed 100. is it correct?2. Fa1/1.2701 & Fa1/1.2717 using "bandwidth 3072". is it correct?3. Fa1/1.2701 & Fa1/1.2717 usin...

Hi FriendI want to connect two ospf back bone are and make it single area, Like two office running ospf and now i want to connect that OSPF area 0 of both office, both are running private IP address .Please let me know-Minu

Dear experts,1. Do the above mentioned Routers series of 1841,2821 and 3825.Supportsdataalong with voice ?.2. If so then which type , whether FXO or FXS or both?3. If they do support voice and in FXO mode then up to how many lines ?4. Is Exchange nec...

HiI have Sun proxy server which is connect my router for internet. My user internet access via proxy. recently I found in MRTG is always high. so How I can findout which users are always download ?.ThanksBiplob

Hi FriendHow to get MPLS VPN Redundancy between two provider like One CE will have connectivity like CE-PE1 ( provider 1) and same CE- PE2 ( Provider 2) , How to get redundancy and failover. Please send me good documents also.-M

Do i have to pay or have a special account to be able to donwload IOS??? thankss

Hello Experts / Cisco Tech Engg,What is meant by enabling the "CPU Profiling" on Cisco Routers.What are that Commands involved in doing / enabling the same ?What are the Advantages & Disvantages of CPU Profiling ?Thanks in Advance for all your HELPSB...

Hi,I would like to know why the pri-group command is not available under the controller xx submenu of my 2600XM router. It is running the following IOS c2600-advipservicesk9-mz.123-26.bin and have a VWIC-1MFT-G703 card.Thanks a lot for your help.

I just added a NM 2W card to my 2621, with a WIC-1DSU-T1 card, and it is not showing up as an available interface. The NM 2W card had the 'en' light on at startup, but now no lights, and it does not appear available. Do I need to do something else ...

Could someone please explain the differences between accepting full routes, accepting default only, or partial routes plus default as an enterprise running BGP? I've heard these options thrown around but I'd like to have it explained in plain languag...