Routing

Dear Experts,On our earlier router we have 4 smart serials and all the links which are configured as Multink bundle are working.Now we are changing the router having 2 smart serial and 2 DB 60 ports and configuring as multilink bundle but it is not w...

Hi guys can you check this config please. It's working ok but if there are any improvements I can do or you see any mistakes let me know please.I put 20 track 20 on the 69.x.x.x ip to give the 70.x.x.x priority is that correct ?ip route 0.0.0.0 0.0....

please , what type of cisco antenna can i used to implement a wireless p2p over 5Km

Hi,I have an ASA with three interfaces: inside, outside and otherlan. On altralan there's an EhternetDevice that must be reached from inside, but not from outside.The relevant part of configuration is:name A.B.C.D EthernetDevice!interface Vlan1 namei...

Hello All, I need suggestions on achieving load balancing traffic( T1 links) with the following network setup Inside N/W-->ASA-->3560 Switch----> 2800 router -- T1 Link (layer 2) | |--> 2800 router--...

Hello Experts,We are running HUB & SPOKE Method. HUB is the PEER Router and Spoke are Branch Offices.Note: 2" PEER Router at HOThe IPSec is established between the HUB & SPOKE Routers. Normally the scenario is: For a Spoke Location when it formed a I...

Hi,I have Catalyst 6509 with 2 supervisor 720, one is Active and the other one is not presented to the switch. When I show the modules I get that the second supervisor is unknown and Not Applicable(See the file attached).the second supervisor is boot...

hi, i want to know if 837 router can be used for VPN IPSEC LAN-TO-LAN for a small branch enterprise where there are 70 users. does this solution is efficient or i should use a 1700 router

A bit of a wierd one tonight guys, basically I've got a 1803 sharing a cable connection (provided from a motorolla surfboard, using all the default settings) using PAT. Everything works perfectlly initially, then after a while DNS lookups stop functi...

we use an access server to provide internet connection to our employees from home. RAS uses E1 and analog modems.RAS sends many log messages to syslog server about interfaces up/down events.how can we disable these messages.i tried no logging event l...

Dear all !I have a problem with Cisco 6509 module. logging like this : - CONST_DIAG-SP-3-HM_TEST_FAIL Module 2 TestScratchRegister consecutive failure count:2 - CONST_DIAG-SP-4-HM_TEST_WARNING Sup switchover will occur after 5 consecutiv...