Routing

Hi all I configured PAT rule so that the vpn traffic from a remote client is forwarded through cisco 2821 router to vpn box (Nortel contivity) the problem is that when IKE traffic received the router forwarded to the client but somehow missing I mean...

thanks in advancehow many fastethernet or gigabit ports supported on cisco 7606 router

i am facing problem in my network topology,i am conntectin two locations one with router1841 and 2nd with 3640 connected with P2P DSL link ,i have ISDN backup but i am unable to dial DDR ISDN once DSL modem will unsync because DSL modem connected wit...

How to configure syslog in 3550 switch?

How to install a HWIC 1FE care in 3845 router. to be specific which slot is HWIC slot and do this require any "slot /card driver".

Can i set one isdn bri lines for both in and out dial, Is it possible?

can we spcify window size on interface?

What is the maximum number of supported T1 interfaces and T3 modules for the ISR's: 1841, 2801, 2811, 2821, 2851, 3825 & 3845?

Can someone help me check that the following hardware will run on my 7604 with sup720 and sip 400.I need to run s72033-ipservices_wan-mz.122-18.SXF2will the following SPA card work ?SPA-1XOC12-POSI am concerned that although I think the IOS release i...

I'm working for an ISP. Since our clients often ask for testing performance on dsl and sdh links in the mpls cloud and I didn't found a method at work except IP SLAs udp jitter operation -which is quite useful, but not realistic-, I started using ttc...

Hi,Our company is going to implement a Citrix Farm at the data-center. There will be 6 presenation servers with two access gateways. There will be 60 concurrent users at a remote site. These Citrix users will be accessing via an MPLS WAN. The data-ce...

Hi,Is OC an aggregation or set of T1's? And how does it differ from IMA and MLFR?Or OC to DS like for example OC12 vs DS3Thanks

I believe I have to contact ISPI checked the dsl operating-mode is in autoI noticed my DSL downstream has only 7db for 3 monthsI changed from auto to dsl operating-mode ansi. Now the signal is 30db.Wondering is there any command I can identify which...