Routing

Folks, I need to provide cable requirements for a building where CAD engineering folks will be working.How about cabling that with Cat6a in order to take advantage of 10Gig for those workstations which normally need to collaborate with other engineer...

Hi, my T1 to the internet is dragging. I have a lot of users on the one T1 but I suspect that there is something wrong with the config as well. The serial interface has a MTU set to 4470 and it is Point to Point T1 connection. I thought that 4470 MTU...

Hi,We have the following setup:RTRA & RTRB located in site A both are OC48 connections.RTRA connects to RTR1 in site B, then to internetRTRB connects to RTR2 in site C, then site C connects to Site B and then to internet via RTR2.Link from RTRA to RT...

Hi,I have an Frame relay link point to point,and currently experimentes Output Drops.Serial0/0/0:0 is up, line protocol is up Hardware is GT96K Serial Description: *** Data Link to AVON KASTRIN *** MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, ...

Imagine I have the following:client1--WAAS1--RouterA--WAN---RouterB---WAAS2--client2Assume RouterB is configured for wccp. When client1 sends a packet to client2, I understand that RouterB would process the wccp 'access-list' and verify that the pack...

How would I go about and set inbound ftp tcp port 21 to a inside network address.. And also having problems with setting wpa on the wireless side.. The router is a 871W... Thanks Tom

Hi !i have demand to support 8x10GE interface on PE device can you suggest optimal platform (7609 + es20) or something else.this will be used mainly for voice traffic

I have an 851 router which has a very basic configuration on it. Everything seems to be configured correctly, however I am having trouble accessing my web server. I can only get to it some of the time. The rest of the time it times out. It seems like...

Single Site:1. Two internet routers : Router1 : 10Meg Internet line--> router managed by ISP1. BGP neighbor configured for upstream ISP1 rtr. Router2 : 2Meg Internet linee ---> Router managed by cleint. BGP neighbor with upstream...

We have a backup interface (dialer2) and we want it to generate a SNMP trap regarding it UP status as soon as it comes up. We tried to change SNMP timeout and queue length but that did not help. Also we cannot specify source interface of SNMP traps ...

what type of WIC card is this: WIC Slot 0: FT1 BT8360 Hardware revision 1.3 Board revision B0 Serial number 25579109 Part number 800-03279-04 Test history 0x0 RMA number 00-0...

What is causing a significant amount of the message (A segment before this frame was lost) in traffic on a MPLS routed WAN. Any help is appreciated. Running IBGP on MPLS backplane. Errors only noticeable on DS3 pportion of circuit. The following is D...

We're migrating to VoIP and hear discussions about voice enabled routers/switches, our WAN is based on 6513\3825\3845, does these devices support voice or would we have to implement new infrastructure?

I have layer 3 cisco Catalyst 3750. I want to configure it with two ISP link. I wana use both links of ISP bandwith.My PIX firewall will connect with this switch. Firewall has different subnets. Like 172.28.92.x and 172.28.32.xI want 172.28.92.x traf...

need a converter which can convert from Gigabit Electrical to Gigabit Optical for cisco 4507 switch.1000 Base - T to 1000 Base SX is correct interpretation or not?????please suggest any alternate product .