Routing

Here is my topology and my problemRouter (R1)Serial 1/1 connected to s1/1 of R2 12.0.0.1/30Loopback 0 100.0.0.1/24Router (R2)Serial1/1 connected to s1/1 of R1 12.0.0.2/30Serial1/3 connected to s1/3 of R3 23.0.0.1/30Serial1/2 connected to s1/1 of...

Hi All,I have a query as follows:X NET (100.200.1.X) ------[(NAT outside int)-NAT Router-(NAT inside int)] ------- Y NET (192.168.1.X)Suppose I have configured NAT to translate 192.168.1.x network to 100.200.1.X.If I ping/trace from X NET on NATted I...

I have a 871w connected to a cable-provider in Vienna, Austria.The speed should be 16384 mbit download, 1024mbit upload. But I only get something like 3 mbit down, sometimes peaks of 5 mbit.I run the test with an ISP-provided testsite (1MB file per P...

I am using an 871 to connect to an ISP that requires my outside inteface to be in DHCP mode. I give the ISP the MAC address of this interface and my "static" IP is assigned via DHCP based on this MAC. Now I need a second IP and the ISP is asking fo...

I've read some BGP Limitations in student guide of BGP. "BGP does not enable one AS to send traffic to a neighbor AS intending that the traffic take a different route from that taken by traffic originating in the neighbor AS."Is it 100% correct? As i...

HiIf i create put encap frame on a main interface and create a sub interface and then I delete the sub interface using no int se1/0.1 etc . By doing the above no int se1/0.1, will I see se1/0.1 when i issue sh ip int brief or will i see it as deleted...

Dear ExpertsI'm unable to access certain applications from the LAN sitiing behind a cisco 1841 router with the following flash flash:c1841-ipbase-mz.124-1c.bin"I'm also unable to do Remote Desktop to servers on the lan behind this router and I'm unab...

Can you point to documentation or send me a link with documentation that details disabling or deactivation of MAC Learning for an E-LINE service?

Hai all,Can some one share any links which can provide Basic to indepth deails of IS-ISThanks in advance

Hi !I tried to use the CSM Modul in a C7613(SUP720) (unsupported module)- unfortunately I have to use the SRB Images as I am also using SIP/ATM Modules.Do you know - or can you provide me with some info - if ths CSM Modul is supported on a C7613.Is t...

Hi,We are having one router connected to two ISPs. We need to load balance betwwen two ISPs. Also our website is published by ISP 1. Obviously , we need that website is available even if link to ISP 1 fails. Then ISP 2 should publish our website....

Is it possible to have 2 different protocols (bgp and eigrp) in the routing table with the same cost and the same destination? (maybe change bgp administrative distance to 170 same as eigrp) If so, how does the router determine which protocol to us...