Routing

HI,i have never configured QOS.currently we have T1 for Internet access for about 200 people.the second T1 is on the way (it is a 2XT1 bundle , waiting for a WIC to arrive to complete migration).Now i need to allow good Internet browsing experience f...

Hi, Could you say me if it is possible to use "nested policy-map" on Cisco 2600 I'm using Cisco 2621XM routers with 12.3(6) IOS. I think I read somewhere that it's not possible but I'm not sure. Thanks

Hi All , While seeing a route in BGP it is showing Rib-Failur . Can anyone put some light on i t. The snapshot is given bellow.Router#sh ip bgp v v test_vrf 50.50.50.1BGP routing table entry for 12641:20772:50.50.50.0/24, version 228642Paths: (2 avai...

hi, i issued command " show cable host access-group" at ubr 10012 and found a lot of cpe with ip address 0.0.0.0. i use the command( clear cable host xxx) to remove 0.0.0.0 entry. But dose anyone know the reason why ? how to remove it more efficien...

Hi,Can anyone give more information about the vlan database in the router.cheers

Hi,Does anyone know if the 3750 standard image supports object tracking ?I have 2 floors in a building with each floor having a single WAN link out to a mpls cloud. I planning to have a L3 link between the 2 core switches on the 2 different floors an...

Hi There,I'm a bit lost why adding a simple NAT config onto our cisco 7206VXR can cause the CPU utilization to go from 25% to 50% and higher, causing the router itself to become sluggish and unresponsive at times. Removing the "ip nat outside" config...

Hi!I an running Cisco 6006 WS-X6K-SUP2-2GE with WS-F6K-MSFC2 module. Currently It is installed software 12.1(26)E3 in my MSFC2 module. I would to upgrade mu IOS to the 12.3(13) vers. It seems that i can not finde any excat information regarding my ca...

We had just purchased a new 2821 ISR. It is setup on our network and we are able to establish an Internet connection if we embed the address of the routers internal interface in the gateways configuration. What do I do to convert the user community a...

I am new to QOS issues and was wondering if someone could give me some tips.I have three queues configured1)Voice2)Management traffic3)Web, email etc...How can I check if web, email traffic are waiting too long on the queue, being discarted or any ot...

Hi, I have two 515e's at different locations which are currently connected using a L2L vpn. We have just had a managed BT MPLS link installed. We gave BT our internal network ranges and they confirmed their side of the work has been completed. what I...

Hi Sir,Please refer to attached network diagram.I need to configure redistribution such that all routers have full IP reachability to all other routers.Kindly advise how should I approach the redistribution given this seemingly complex multiprotocol ...

I have two sites connected with an E1. Is there any way to setup interavlan routing between the sites? They are connected with 2610's, which can be swapped out if needed