Routing

See attached:

Hi All,I've got this problem.First let me post my acc-list.access-list 101 remark ====== OUTSIDE INTERFACE ACL =====access-list 101 deny ip 192.168.0.0 0.0.255.255 any logaccess-list 101 deny ip 172.16.0.0 0.15.255.255 any logaccess-list 101 deny...

i have many discard error when i monitor my routers by solar wins1) please expain what is this error?2) how can i solve this issue?

I have an Internet Router with 4 seriel Interface, each of them connected to an E1. The first 2 ports have been Multilinked and is working fine. However when I tried to Multilink the other 2 lines as a second Multilink, I could not do it. The ISP say...

Hi CAn anyone help with this..everytimw i try to TFTP a new IOS i get the following error.Loading c870-advipservicesk9-mz.124-9.T.bin from xxx.xx.xx.xx (via Dialer0): !%Tar checksum error in tftp://xxx.xx.xx.xxx/c870-advipservicesk9-mz.124-9.T.binha...

Dear sir,iam having pix 506E on that suddenly iam not getting powr & ACT & network.inside of pix a small redligt is glowing.i changed he adaptor also but iam not getting POWER light and through console iam not able to boot.If anybody tell me what is ...

Hi team, I have two 2960 switches and a 3845 router, The second switch acts as a backup to first. We are planning to add another 2800 series router for redundancy. We want to use it for redundancy and also use it for loadbalcancing. We have 5E1 on th...

I'm trying to setup a 857W router to get an IP address(DHCP) from my Cable Modem connected in one of the ethernet ports.Not sure if I can do it with this router. Or maybe I am wrong doing the routing part.Can someone help with the issue.Cheers, Juan.

Dear all,what is the difference between E1 links, leased lines and ISDN links?thanks in advanceraj

Hi Sir,Please refer to attached frame relay network diagram and associated router configs.The 4 routers are interconnected with hub-and-spoke PVCs with R4 as the hub router. All config is done at physical interfaces (no subinterfaces). I disabled FR ...

I'm setting some PPPoA pvcs and I'd like to permit customers to configure their CPEs for either static or dynamic IP addresses. All the "customers" in this scenario are part of the same company with centralized IP mgmt, so there's no need to enforce...

The current system memory configuration is on a router 3640:SIMM 0 SIMM 1 SIMM 2 SIMM 3 --------------------------------------32M-DUAL 32M-DUAL But I'm on a 32bit mode and when I look at the supported configuration, I have :Supported 64...

I was given a task to change over a site from one provider to another. I do not have site access as of yet so I am gathering information remotely. a sh run shows no T1 controllers and only a serial interface with an IP. Then a Fa0 with an IP.Now the ...

I have a point-to-point T1 between sites in TX and NC and they are having an issue I think may be timing related but I'm not sure. I don't know how to view the interface to see what the timing is set as. Both sites have 1700 series routers with WIC...