Routing

I get this notifications from switch for some ports:5-NotificationPort Fa3: This port is blocked by Spanning Tree Protocol (STP).5-NotificationPort Fa3: Detected a possible over-utilization of the switch link or bad frames generated by the connected ...

hi,the following appears when i apply the sho cdp command on a cisco switch, can any one help me to understand what does it mean when the cdp said the port Gig0/1 is connected to mor than a device ??EngB1140S0#sho cdp neCapability Codes: R - Router, ...

Dear Experts,Iam planing to implement point to multipoint connectivity in central location i want ethernet failover and iam attaching the diagram also kindly go through that and suggest me the ip sceem and config examples.Regardssrinivas.D9246571397

Hello every body,We have a client that want to have a sharing between two providers (Provider1 and Provider2), 50% of the Internet traffic on the provider1?s link, and 50% of the Internet traffic on the provider2?s link. The sharing wanted must guara...

What is the best way to forward a port range to internal ip address and don't lose the router internet access?My situation:I've a SHDSL connection with 878 (IOS version 12.4) and one public IP.If I configure:"ip nat inside source static <private ip> ...

In the dynamic ordering tool for the 7600, I can not find the card: Cisco 7600 Series 4- & 8-Port OC-3c/STM-1 POS Enhanced Optical Services Module. Do you know why?

When I modify or remove vbr-nrt command for a configured PVC the traffic stops passing through.It started happening with 7600 router earlier with 7200 it never use to happen Is their a workaround other than restart or recreation of pvc.

Hi allI'm wondering if header compression is inherited by the subinterfaces for an atm interface as the command of ip tcp header-compression is not availible for the atm subinterface like that of a serial or frame relay interface.How can i configure ...

Hello Dear Guys,Here is a plan of a MAN network.the routing protocol is osfpthe areas in map are shown,but because of network convege time and other parametrics, please hint me for osfp areas and anyother thing you think about.regards

Hi Guys,I am little bit confused about the term layer 3 switching i.e hardware based routing.can anyone explain or proivde a link which explains this.ThanksMahmood

hello Anybody here knows how to set a password to my router??how can i do it?thanks

can not read compact flash cardcannot open flash

hi all,I would like to know 1. the difference between access rate, CIR, MinCir.2. what is Tc (committed rate measurement interval), and what it has to do with burst.correct me if I'm wrong,access rate: is the max bandwidth at which frame relay interf...

Hello.. Any body here who wants to share their expertise in router configuration and installation?Can you give me the step by step procedure on how to do router configuration and installation..thankpaul