Routing

Hi all,I am trying to see if the traffic to/from port 5060 is passing through my router. Is there any easy way to do this apart from port sniffing.I need to see if my SIP RTP are going through the router.

Hello! I am not sure that my question is in the right topic, please correct if not. So, I really need help of Cisco GGSN experts: In the GGSN R7.0 there is the feature "hold back timer" which I can administer via the parameter "recycle delay" in the ...

Hi1)i have to know about when & where we have to use the dialer watch in the ISDN Technology?2)what about the route tag?when & where we have to Taging The Route?10xs in Advance

Hi , i am facing a typical problem that cisco 3660 is not able to activate the 16 port A/S Module .Following is the Message i get when the router boots !!16 A/S is in slot 2 and is a new module .MEMINIT: No iomem table entry for pa type 0x391 in slot...

Hi,I am getting following message in TACACS failed attempts log.Message Type: Unknown NASRegardsSKRAO

The detailed network diagram is attached. the default gateway of the inside servers is ASA 5520.PROBLEM:Traffic coming from XYZ Branch to the scorpio and alpha server when reach the server, they send back the packet to their gateway which is ASA 5520...

Hi,I am configuring PPP multilink on 3845 router with ios version 12.4(5b)After configuring multilink interface on router it showing "down down"I have one doubt loopback interface after creating shows " up up " Like that multilink interfae won't sh...

Hey guys,I have a 3825 gw, mgcp , that has a pri configured on it. PRI is up and working. The CCM(4.1.3sr3) that controls the GW sees it with no problem. When I try and configure route groups for a route list, CCM does not see the PRI as an available...

Hi, Any Cisco TAC engineer there?I got this un-readable code in SHOW LOG. any idea?=======================ROUTER-B4# sh logSyslog logging: enabled (9 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns) Console logging: disabled M...

1. Did anybody observe any problems when loopguard is configured on all ports of the switch (not just root and alternate ports)?2. Can anybody confirm that MST has built-in protection against unidirectioanl links, so loopguard is, say, less important...

Unit works fine for 2 to 3 days and then blocks all packets EXCEPT ICMP. Restarting the unit corrects this problem until it starts again in the 2 to 3 day timeframe. The unit also has a VPN configured on it for remote access using the Cisco client....

Hi, See my config bellow. I have a webserver directly connected to fa1/0 with an IP of 10.1.10.10 with xover cable. fa0/0 is directly connected to the internet. With the access list and NAT translations, no one from the internet (or connections origi...

can we take the isdn connection through serial interface and than it can be channelised(pri).please send explain in detail b'coz i m jonoir in this field.in advance thank u

Hello together Did someone ever configure a Catalyst 3750 (IP Base Image) with multi VRF and EIGRP Stub? Does this work?Regards Lars