Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear All, I Have a multi provider datacenter. all of them connected to my core router interfaces. One of them is VPN who is my tunnel interface. The second one is VSAT that is connected to my ethernet interface on core router. The third one is connec...

emadehsan by Level 1
  • 299 Views
  • 2 replies
  • 0 Helpful votes

HelloI have a cisco 871 with ADVANCED IP SERVICES 12.4 9T1 IOS . i check on cisco Cisco fature navigator site i see that this module supported virtual profile featur .this router have vpdn groups and accept vpdn connecion via L2TP/PPTP . but when us...

i have read some where that if we want to disable routing all we have to put is no ip routing.........i have did that on static routes but when i put the command show ip routes it was shows that routing cache is empty.........and it was not even show...

Hello,I've got a problem and I can't seem to solve it. I've got 2 SDSL connection and one VLAN and I am trying to Load Balance the 2 Eth WAN connections, connected to eth0 and eth1, for the vlan, or at least configure them to act in a fail-over kind ...

g.heymans by Level 1
  • 2825 Views
  • 6 replies
  • 0 Helpful votes

Hi Guys,Can I ask a question in regards to synchronisation. (pls see diagram)Actually two questions here. How Sync works, and order of operation for BGP and Routing Table (RT)If I have the following topology, the statement I would like to make is ...

I currently have an 871W set up with the entire private, inside class C translated to an IP on the outside interface (F4). We currently have one web server on the inside which has 80 and 443 forwarded to it from the router, but will be assigning ano...

melon_2 by Level 1
  • 404 Views
  • 1 replies
  • 0 Helpful votes

Resolved! 3640 IOS problem

Hi,I up loaded a wrong IOS on my 3640 router and it is not showing ATM module in IOS. IOS installed is Version 12.3(19), RELEASE SOFTWARE (fc2). I have NM-1A-OC3MM module. Can someone tell me correct IOS. RegardsMeer

meerz by Level 1
  • 1314 Views
  • 5 replies
  • 0 Helpful votes

We have two multihomed ebgp routers using the same AS number that advertise our routes into our carrier. The routers connect into the backbone using eigrp. Routes are only announced into BGP, eigrp is not redistributed into bgp. Is there anyway to...

HiIs anybody doing GLBP with BGP? Anything special that needs to be done for BGP to work? My second question is how do I get GLBP working on a subinterface when I only have a /30 from my ISP?

I curently have a Cisco 1720 router that we use for our Internet access. We currenty have 2 T1's configured and are looking to upgrade to 3, possibly 4 T1's....Can someone please inform me what Cisco router can support 4T1s?

We recently converted 22 sites (1 host 21 remotes) from Frame to MPLS. I now want to use a routing protocol. My routers do not support BGP so I'm thinking OSPF. Unfortunately my MPLS carrier won't support OSPF so I'm thinking a bunch of tunnels from ...