Routing

Hello,I have a 7500 router connected to 2500 router using OSPF across the WAN link. For some reason, with OSPF running it drops the WAN link. Making the interfaces passive, and using static routes brings the link back up.This has been working fine in...

Hi All,I have many routers (> 30) that currently uses EIGRP for routing. I am using 10.10.0.0 segment (example only) , and subnets exists everywhere. Topology is hub-spoke.So, in my router, the eigrp config look like below:router eigrp 100 network 10...

Does anyone know if PPPoE can be configured on the Ethernet WAN Link of my 1801 router? fa0 will obtain a IP address thru the Speedstream 5100 and the NAT overload command seems to work fine when applied to the interface. The difference is that I can...

i have many sites connected to our main office router....one of our remote office has got 64K link which is ocnnecting to out main office.....while going htrough our main office router i saw a config rate-limit input 64000 2000 3000 conform-action tr...

Hello,I have a 7204 Cisco Router with T1 inteface and the traffic is supposed toto outputing to the Fastethernet portI was trying to monitor the trafficI have looked at the sh intsh int statsh int accountingand I see a different in the in the traffic...

i want to access my remote router console using aux port by modem can someone help me to provide what configuration has to be done in both endany help highly appreciated

hi,i have a hub router which has crypto connection to a spoke router.konfig:!crypto isakmp policy 10 authentication pre-sharecrypto isakmp key 321tmobile(max) address 10.18.239.243!!crypto ipsec transform-set xyz esp-3des esp-md5-hmac !crypto map aa...

Cisco's Security Auditor makes a recommendation that the command "ip route 0.0.0.0 0.0.0.0 null 0 255" rapidly discard packets with invalid destination addresses.Link is at: http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080...

We are moving our retail environment to a frame relay DS-3. All our stores will be sub-interfaces. On the remote end (store side) we want to take advantage of EIGRP stubbing. I have enabled this at some test locations and still see a full routing ...

i need to Add a new VIP card in a 7500 does it need to be turned off?

Router is a 1760 with 2 T1 WICsWe have added a 2nd T1 Internet connection to a different ISP. By default, all traffic will go out the 1st connection because it's route has a lower weight.We would like to have VPN traffic leave the same connection th...

Hello,why "ignored" interface error constantly incrementing on the management VLAN (in this case vlan1000) of a catalyst 2950 enhanced image IOS 12.1(22)EA6.Thanks.