Routing

Hi,Could anyone tell me if the above mentioned HWICS are configurable as routed ports. I would like to assign an IP per port ?Thanks

Hi i have study about the Bgp damping fron cisco site and different Bgp documents. but still confusion ,,, can you tell me about it in simple wordssWhat is the purpose of bgp damping ????what is penalty ????and suppress limit of prefix????Why we wan...

when configuring a router for a security baseline, and entering the command no ip domain-lookup, the terminal session and the router both hung. router is a 3745 using (C3745-JS-M), Version 12.2(13)T5 IOS. what happened. had to power cycle router to r...

HiI have a remote site which connects back 2 X 2Mbps back to headquarters. This is 2 point to point connections. I would like to load balance the data that is passing thru this link. Currently below is my router config :-interface Serial0/0 bandwidth...

Hi All,I will be moving to a new mpls soon and wanted some input on my config. I am currently running eigrp inside my host network for all of my subnets. what is the best way to get my local networks into the ebgp config and out to the provider PE ...

Good day,please, what command can be use to see the card inserted on the router. like see exactly the kind of serial module: wic-1T , wict62T etc..Regards.

Currently have a 3725 router with 3 WIC cards terminating 6 point to point t1 circuits. We will be adding an additional 3 point to point circuits with possibility of adding more. Can this router handle 9 or more point to point circuits? If so, how ca...

I have the following scenerio I desperately need a solution for.I have a long haul T1 link. I need to bring this T1 into a device. At this device I need to share this T1 to two internal customers. I need to map 20 Ds0's of the T1 to a internal port a...

We have recently setup a PVP to a provider to provision Layer 2 DSL services. We have the following on our 7200:!interface ATM1/0.36 point-to-point description ATMI Interconnect with Provider bandwidth 2000 no ip route-cache pvc Provider_Intercon 11/...

Hi All,I will be running eBGP through my pix to routers on each side to the loopbacks of these routers. what must i enter in my pix config to allow these two routers to exchange via bgp with their loopbacks? I have tried just allowing the port, but ...

I am new to Cisco routers and would like some help to connect 2 internet connections to our LAN and provide load balancing or failover (prefered).The 2 internet connections are provided by different ISP's. I have 1 Cisco 2600 router from ISP1 and a ...

I would like to disable ssh on my 1711. I am trying to have a machine inside my network (NAT)answer the ssh login. I have the following:ip nat inside source static tcp 10.10.10.100 22 interface FastEthernet0 22 It does not seem to work . The router k...

Hi, Sometimes my routers loose connectivity, when I go back and I check their serial interfaces I see carrier transitions as well as interface resets. When I use the show service-module serial command I have "Receiver has no alarms". My question ...