Routing

-- 3750 --- - - (ds3)cat4500 --- ----- cat6500 - - (ds3) -- 3750 --- If I want to load balance between the two 3750 routers. Should I run cef in cat4500 or run cef in two 3570 rou...

Hi There,A customer has asked us to configure a router for them that was previously used. However the previous engineer has configured a ROM Monitor password. Is there a proceedure to reset the ROM Monitor password? This is a Cisco 805 Router.Many Th...

hi!Dear allI have a BGP router learned a route through two way:one through eBGP,one through iBGP.For I preferred the iBGP path so I use route-map to set the eBGP route's origin to incomplete(the ORIGIN attribute has a higher priority in the decision ...

Microsoft netlogon communications fail across a NAT. Microsoft documents this issue at the following link:http://support.microsoft.com/default.aspx?scid=kb;en-us;172227Does Cisco NAT support the Nating of the Netbios header address in addition to th...

HiI have noticed that after configuring generic traffic shaping on a GRE tunnel on a 3660 with IOS 12.2(28a)- the show interface command returns wrong information - I have searched for bugs desribing this problem but haven't found anything. Has anyon...

Hi Friends...I am struggling with this type of ethernet interface on 3640 as I need it to support 100 Mb whereas I read somewhere on net that this type of hardware "AMD Presidio2" won't support 100 Mb. Max this type on interface would support is 10 M...

There are some voice network module and vic card version 1 for cisco 2600 and 3600. Do these voice cards work on 2800 and 3800?

sh versCisco Internetwork Operating System SoftwareIOS (tm) C2600 Software (C2600-IS-M), Version 12.2(11)T11, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2004 by cisco Systems, Inc.Compiled Wed 14-Apr-...

Hi,I was wondering if cisco devices, routers, asa etc... can sync with an external NTP server and then also play for NTP server for other devices?Regards,

Hi All,Actually i am confused with OSPF behaviour for Non-broadcast multiaccess network..First take the case of RIP.If we configured the RIP in Non broadcast multi access network it is working.. But RIP send the Route updates to neighbor routers via ...

I have customer having two internet inks terminated on to two routers.Is there any Cisco solution (or a box) which can do internet load balancing in this scenario ?( Customer does not want to invest in running BGP etc in his routers)

HiI checked link point-to-point HDLC between router A and router B, i saw Line protocol on router B down but on router A is normally then i debug serial interface command on both router to see keepalive messages . I found some question about output k...

hallo I have a problem with a cisco1801 IOS (c180x-broadband-mz.123-8.YI2.bin) that does not get sync on an ADSL line. On the same ADSL line a cisco1841 does get the sync.This is the "sh dsl int atm0/0/0" from cisco1841:cisco1841#sh dsl int atm0/0/0A...

I am trying to find a way to aggregate 2 serial links that are being connected though an ATM cloud. So that the networks on both sides see them as one link.(see attached)