Routing

I have customer having two internet inks terminated on to two routers.Is there any Cisco solution (or a box) which can do internet load balancing in this scenario ?( Customer does not want to invest in running BGP etc in his routers)

HiI checked link point-to-point HDLC between router A and router B, i saw Line protocol on router B down but on router A is normally then i debug serial interface command on both router to see keepalive messages . I found some question about output k...

hallo I have a problem with a cisco1801 IOS (c180x-broadband-mz.123-8.YI2.bin) that does not get sync on an ADSL line. On the same ADSL line a cisco1841 does get the sync.This is the "sh dsl int atm0/0/0" from cisco1841:cisco1841#sh dsl int atm0/0/0A...

I am trying to find a way to aggregate 2 serial links that are being connected though an ATM cloud. So that the networks on both sides see them as one link.(see attached)

Hi, I have a site with three distinct departments that need to traverse two different PVCs on the same choked DS3. They teminate at a 3745 with 4 ethernet interfaces, dept. A (WIRE) uses f0/0 and f0/1 (one for backup) dept B (BRANCH) and C (IMAGE) us...

Hello,one of my customer encounters a problem with a 7606 in version c6sup22-jk2sv-mz.121-26.E4.bin.When he changes the encapsulation ( ppp to hdlc or hdlc to ppp ) on his serial interface the service-policy configuration is removed.Exemple :xxxx02#s...

Hi I have 3725 router. due to insufficient flash i would like to boot the router using tftp. I want to know command to proceed. will i be able to download 64 mb file into memory.

I am in a process of upgrading a remote location from a T1 to ds3, my initial thought was to install a 3660 for the ds3. But wanted to some other remote end series router which is going to be suitable for ds3.Any help would be appreciated.

hi!Dear allI have implement a route-map in my bgp configration to set community attribute of the routes that will advertise to a eBGP peer.but it doesn't works : "show ip bgp community no-export" show nothing from the eBGP peer;below is my configrati...

I have PIX behind a router with 2 WAN interfaces. Main interface is for traffic and it fail over if it goes down. I have PBR enabled for traffic from the PIX, it fails over great. In order to allow remote IPSEC sessions I have two static translati...

hello, my question is the following, I have a cisco 2600 router connected to a T1 line and a 30 Mbps cablemodem line, I want the cablemodem as my primary connection and the T1 as my backup connection, when the cablemodem goes down, I want the T1 up a...