Routing

All,Attaching below the diagram of the network which I am trying to configure, the configuration is as follows: An L3VPN from a Service Provider has been configured and working fine, we are connecting to the Provider managed CE through a 2811 routers...

Hi allI have a 837 ADSL router running at the moment connecting to corporate network via a VPN connection. The current VPN setup only permit certain IP address ranges (from corporate hub site)to reach this ADSL router. What I needed to do now is to e...

Hello,i am in france, and the ADSL routeur 837 (for Internet) give me some probleme due to the disconnecting some times.The ADSL work properly but some time, it stop to works.When i debug, i have this (in attachment.Do you have any ideas about theses...

Will this Supervisor Card support 802.1x?

dears i have 1751 router connected via Frame-Relay primary and isdn backup. i found that isdn make calls although frame-relay is up . here is sample of debug dialer ouput 4d02h: BR1/0 DDR: place call 4d02h: BR1/0 DDR: Dialing cause ip (s=20.0.0.44, d...

Hello All:Having an issue after adding a 3.x segment to our network. This may be difficult to explain but here goes. Also attached a diagram which should prove useful.Network segemented 1.x, 2.x, and recently added 3.xRouter A - 3 T1's servicing 2.x ...

Can i've more than one mroute: one pointing to the Rendezvous point (RP) and the other pointing to the Mapping Agent?We need an mroute command to violate the RPF check and make it point to the RP...but the case is when having an Auto-RP environment a...

Is't possible using SNMP collect information about used FXO-ports and E1-channels?

I have problem interpreting the show rtr operational-state and show rtr collected-statistics,the values from the counter seem to give conflicting results

Hi Guys, Im trying to access my home lab remotly using telnet. My current topoloy is as such; ---->DLSModem --- LinksysRouter ---- InsideNetwork My inside global address is say 81.7.164.245 My inside local address for the router is say 192.168.1.5 an...

We have removed a software from flash memory, and replace it by a new software.And we have format bootflash memory and replace it by a new sofware.The UBR7246 can't load memory normally, we have some error while booting:System Bootstrap, Version 11.1...

I currently have two 3745 Routers that I would like to take the built in fast ethernet interfaces and configure them for etherchannel. I have run into a problem however. I can create the port-channel interface and I can also add the fast ethernet int...

Hi.We have installed an E1 line that would connect remote ofiices to the central site. The telco has told me that only two of the channels has been activated.The telco only provides physical layer transmission.thanks How would you configure each chan...