Folks I am here again for your valuble suggestions.We have Branches and Big sites. As more and more applications hosting in the cloud and all the data heavy Applications like Webex and Teams needs internet. How do you accomplish Maximum uptime and le...
Forum Posts
Resolved! vEdge authentication
Assumption: to receive a device certificate, the (virtual) vEdge generates a CSR to a vManage of a fabric.Doesn't the vEdge find the vManage through the vBond? Are unverified vEdges able to find the vManage of a fabric before the vBond of the fabric ...
What is the purpose of using preference inside tloc list?and can we see the changing on the cEdge? In almost cases I use preference via topology policy and I can see it through command sh sdwan omp routes and nevere use preference inside tloc list
Can I build L2 channel by using sdwan devices? maybe as l2tvp3 (xconnect) tunnel between two sites?
today ,when we tried to terminate 500 Mbps internet link of primary Vedge 1000 then we got reply that---this link will not work as V1000 has bandwidth limitation of 250 Mbps .May I know what is this bandwidth limitation concept in cisco ?please share...
Dear Cisco Community, Consider the SD-WAN Topology diagram attached here. I need to configure reachability end-to-end between the referred locations. Basically, in site-id 10, it has service VPN 10, and on the other side, on site 20, it has VPN 20. I...
I am using vManage version 20.9.3.2. By default when the vManage CPU utilization increase by certain % it is considered as Critical & it is shown in the dashboard.I would like to understand the below.1. What is the default % which is defined as crit...
Dear Cisco Community, The DLTS control connections are up, but BFD sessions are down, with exeception of just 1 BFD session. Follow the outputs and topology in attachment.
Hi, I need to add an ACL to an interface to only one router in my sdwan network.It is connected to an Internet connection and I want to permit only to establish the tunnel.Where can I create it? add it in a template?I want to configure something like...
Resolved! SDWAN - Vedge memory issue
Hi, I have cisco router ISR 1100 running viptela OS in SD-WAN environment. I am getting memory warning randomly on different vedge device. Just checking with our cisco community that if anybody has seen this sort of health warnings ?Happy to send any...
Has anyone in my friends' network tested SD-WAN 20.9 and configuration groups? I'm testing version 20.9 in the lab and during deployment I get this error regarding BFD. I tried CSR1000v versions 16.12 and 17.3 and I have the same symptom. I have chec...
Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Start here by unlocking the full potential of cloud networking with our latest article, 'Interconnection of Cisco SD-WAN and AWS Transit Gateway.' In this deep dive i...
I have CLI template with configurationlogging discriminator auth mnemonics drops AUTH_PASSEDlogging console discriminator authlogging buffered discriminator authand after downgrade cedge from 17.9.4 to 17.9.3 I noticed that couldn't change values in ...
Hi We are going to Migrate our Legacy infra on SD-WAN . As per cisco document AMI images for controllers will be pushed by cisco in our AWS account but When we are trying to contact cisco. Link is showing broken.We are going to host the controller i...
Once an edge router has contacted vBond and successfully joined the overlay, after its transient connection to vBond has dropped what network conditions (other than edge reboot) would trigger a re-authentication to vBond? We had a situation where the...
