Hi Team,I need some information about the behaviour of topology on which we are going to upgrade . Current Scenario ( Fig-1)We are on the legacy network and using Nexus as an Edge device. Our WAN links are terminated on the nexus. All the traffic fro...
Forum Posts
Dear Experts,While doing redistribution from OMP to OSPF, cant we set the type E1 and associated values?
Hello I am reaching out from an Amazon site about getting some rail kits for C8500L-8S4X. We did not get the rail mounting kit in out box. Looking for some assistance in this matter
I've pushed some device templates to some devices but status of two of them has been changed to "Device Out of Sync - Failed to attached template". I rolled back my configurations but the status of these devices are still Out of Sync. what should i d...
Hi , I have a multi HUB SD WAN network . In GUI you can enter the monitor network and on real time test on demand remote but it has no details. Is there a command in CLI or other GUI option which will tell me how many site are working with each HUB ?...
Microsoft Hyper-V support for Cisco SD-WAN on-prem controller(Vsmart,Vmanage,Vbond) is available or is it supports VMware vSphere ESXi Infra only.
Resolved! SD-WAN and the internet
I am having a debate with a colleague and wondered if some of you could please clarify: If I implement an SD-WAN accross several sites my understanding of the benefits are:1) Connectivity is secure between the sites2) I can use any internet connecti...
Hello,I want do change in edge device via CLI mode... But I getting error device is in vmanage mode... Imp:-I don't to remove device from vmanage mode. I want do change in vmanage mode only but via CLI command.. If this possible then please and plea...
EPLAN circuit has 30 different endpoints.Some have 10G, some have 1G, some have even less.Is it possible to:shape traffic from a 10G circuit towards a site with a 1G circuit to 1Gpbsshape traffic from a 10G circuit towards a site with 10G circuit to ...
Hi Guys.We have a weird problem where there is huge amount of packet losses noted on the network during normal working hours. We did the changeover to SDWAN in the weekend and everything was fine. However, things went really bad once Monday business ...
Hi, Anyone successfully setup a cellular interface on ISR4K using NIM-LTEA-EA module and vManage? I have the below config but i can't seem to get it to work. !controller Cellular 0/1/0lte sim primary slot 1profile id 1 apn vodacom authentication pap_...
Hi,I want to apply <ntp access-group> to some cedge devices but i did not find any feature template in vManage related to the NTP access-group. the following configurations:ip access-list standard 20permit 10.10.10.1 0.0.0.0ntp access-group peer 20nt...
SDWAN version of the Cedge router support Service-side NAT-ALG ？ I checked the following commands on Cedge show running-config all | in alg show sdwan running-config | in alg
What is the purpose of enabling dns in vpn 0 in vmanage
Hi, We have a setup of a switch template with 28 networks bound to it. However, we are not seeing much value as most of them have local overridden config. Whilst keeping the operations working as it is, if we need to add new switches to the same site...
