Hello, Is there a way to re-install a certificate of a virtual sd-wan edge router without decomissioning the device in vManage?After some error the device certificate disappeared but on vManage it says certificate is installed. I could do a "request ...
Forum Posts
Hello We have setup the lab with 3 controllers (vManage,vBond & vSmart) installed on Vmware ESXI host. The controllers are behind firewall. therefore what are NAT requirements to allow communication between vEdge and Controllers. Do we need to NAT al...
Resolved! Control vs Data Policy
I'm a little confused with something and maybe I'm not confused but the information I'm getting is wrong. I'm new to SD-WAN and drinking from a firehose. Between the gazillion pages of documentation covering 3-4 iterations of config guides and read...
Resolved! SD-WAN BFD timeout
hi everyone - I'm in the way of being voluntold to learn SD-WAN and am looking for some info that cannot be found in the docs or RFC. Talk about having to weed through documentation! HOLY COW BATMAN! BFD is used to determine tunnel liveliness and t...
I would like to ask, if my OMP peers is down with Vsmart(Vsmart Down), how to configured vEdge or cEdge router in such a way that It will track the omp peer and if it is found down, it will forward traffic from under lay network....Note : I'm only us...
Hello For my internship i'm trying to research an SD-WAN. Therefore i'm trying to virtualize an SD-WAN network. I got my vManage, vSmart, vBond and vEdge running, but my server attached to the vEdge doesn't get internet access. Also in the main dashb...
When in vManage mode, what is the best way to change the hostname of a vEdge or ASR router? It can't be modified in device template so do you have to move the device to CLI, update and then reattach?
Hi, We had setting with dual DHCP helper addresses on device template.Recently, I made some change on the device template via [Configuration]-[Devices]-[Change Device Values], but the Change wasn't completed because of dual DHCP helper address.It was...
Hi, recently I read that from CVD, in SD-WAN for Application Visibility symmetric traffic is mandatory. And traffic symmetry is not required with SD-AVC since it is a centralized network service and application states are synchronized between network...
Community Live Forum- AppQoE Deep Dive and WAAS to AppQoE Migration Platforms Tuesday 22 , February 2022 - Friday 25, February 2022 Ask Me Anything Forum In this section, we covered the basics and deeper knowledge and understanding of the lat...
Hi Everyone, I have 6 sites configured in full mesh. However, I would like to stop two sites from establishing Tlocs and OMP between them. Site1 can talk to Site3, 4, 5 and 6 (and vice-versa)Site2 can talk to Site3, 4, 5 and 6 (and vice-versa)Site...
Hi, I am wondering if it's possible to make Site-to-Site IPSec connection between vEdge and any non-vEdge device( ex) firewalls or routers)
Please kindly assist with an EOL for Catalyst Switch C9200L-48P-4X-E
Resolved! vedge router transport side ecmp
folksin my lab i have a vedge connecting to two isps, one on mpls and one on public internet - both are advertising a default route but i only see one in my routing tablei have configured maximum-paths path 4 under address-family ipv4-unicast but it ...
| User | Count |
|---|---|
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 |
