Storage Networking

Hello,I have got two Nexus 5548UP and fabric Brocade.I would like to connect my Nexus at my fabric Brocade.See the pdf file.Best regards,

Hi,Our customer wants now to buy a Nexus 5000 and the:DELL Broadcom NetXtreme II 57711 Network Interface Card http://www.dell.com/us/enterprise/p/broadcom-netxtremeii-57711/pdandDELL 10GbE SR SFP+ Transceiver for Broadcom 10GbE Dual Port Server Adap...

Hi forum,I currently have a single MDS 9124 which my SAN and virtual servers connect to.I have purchased a second MDS 9124 with the view to providing resilient connectivity to my SAN and servers, with a Fabric A/Fabric B design.Example diagrams of cu...

Hi I have a problem between UCS FI and MDS switch port-channel. When MDS-A is powered down the port-channel fails but UCS blade vHBA does not detect the failure of the port-chanel on UCS-FI and leaves the vHBA online. However, if there is no port-cha...

Howdy,Recently had a 9120 stop working on me.  The Status LED is orange, and stays orange.  I read from the Hardware Troubleshooting:"The Status LED flashes orange once and stays  orange during diagnostic boot tests. It turns green when the switch is...

Sorry for asking this kind of question but I'm new configuring switches Nexus, I want to connect a Nexus 5596UP with a Nexus 4001I, I have read configuration guides that are available on Cisco web but some options are not clear enough to me, so it wi...

We have a Cisco MDS 9509  5.0.4(d) connected to these are brocade HP C class switches most have been set to Access Gateway mode but we have two that are in interop mode.When  we attempt to activate any chnages to the active zoneset with get the follo...

Hi,We have a Flexpod setup wherein the UCS is hooked on to nexus 5548UPs and using FC for san-booting the blades. I was doing some failover testing and noticed that when i rebooted nexus5k-A (fabric-A) all the blades (ESXi and HyperV both) on the UCS...

Hi,today I updated two of our Nexus 5548P switches and on both I recieved the messageImages will be upgraded according to following table:Module       Image         Running-Version             New-Version  Upg-Required------  ----------  ------------...

I noticed some high amounts of B2B credit transitions on several FC interfaces.   Most of the other links show 0 B2B credit transitions for both receive and transmit.       Two fc ports (connected to a EMC storage) show the following statistics. fc1/...