Switches - Small Business

Hi,i need some basic help with configuring vlan/routing.Situation:DSL Router - Cisco 300 - XenServer192.168.1.253 - 192.168.1.19 - 192.168.1.10 (mgmt ip)goal is, to reach from inside xenserver vms the internet.vms = 192.168.2.xgateway ip = 192.168.2....

Hello,We have 2 x SG300-20's and 1 x SG300-10.We want to have a few vlans to isolate different departments from each other while still providing access to the broadband uplink as well as shared printers.The setup we would like would be something like...

Greetings,Does a switch a take a performance hit when backing up the IOS to a TFTP server? Is it best practice to not backup during production, or is this not a big deal?          Thanks    

Hi,I've bought two SG 200-08P which have their 1-4 ports who can delivered PoE.Whatever the PoE equipments I plug into those ports, it doesn't work.If I plug a non PoE equipment in the 1-8 ports it's working fine.I can log into the web interface of t...

I inhereited a network setup when I was hired in Febrary of this year, and I'm still figuring things out.I have 2 switches in a server rack.One is a Cisco SLM2048, Ip address 192.168.1.254I can log in and administer it fine.The second is a SG200-50, ...

                   I purchased this switch as an affordable way to deploy POE and to verify QOS marking if the need arises.I have connected NEC phones and have confirmed via Cisco 2960's that the phones are marking EF (DSCP 46) correctly.  I then rep...

Hi all,I am a novice at networking. I have a Cisco SF300-24 devices support PoE, PoE mode on my already enabled. But when I try to connect with wireless radio devices, devices that I connect does not turn on. Is that a problem? Thank you for your hel...

My SG20-50P Switch Log appears as follows with Random ports going up and down.  I am trying to find out if this links to another problem I'm having with a Client Server software locking up on the client end.  The hardware, thin clients and desktops, ...

I have a Cisco AP541N access point connected to a trunk port of a SF 300 switch with 2 WLANs setup.1 for internal use1 for guest useI'm looking to limit bandwidth for guest wireless network users.  Is this possible to do on the SF 300 switch? perhaps...

HiI need to install a number of SF300 switches as a result of large office expansion. I've tested copying Configuration File by setting up one switch, doing a "Backup" of the config file and then on the next switch doing a Download of the file after ...