Switching

Hi, This is Cisco 9500 Series switch stack and I am getting alarmed as "%SMART_LIC-3-RESERVE_HA_FAILURE: The license reservation information on the active and standby does not match. Licensing HA will not work properly: Reservation type in active and...

Hello, Can anyone shed some light in the difference of show output command? My client thinks it is a Cisco bug. But I told him it is a default configuration when you create a L3 interface. He stated like this as below:switch shows strange behavior on...

So after trying to use vrrp/vrrs (and getting no where as it seems nobody has ever tried this on a 9500 based on responses to a previous email) I thought I would try stackwise virtual which to be fair I have had more success with but cannot get dual ...

Hi All, I have 2 x 9500's (Fuji 16.09.05), They are connected by 4 interfaces in 2 port channel group's for diversity.There are a number of vlans configured for vrrp and vrrs (see config below)Switch 01interface Vlan31description Chem-GF-Voiceip addr...

Hi,Is there is way to use pipe command with "show module" to display only the first table?Or is there is other command can display only the first table?The target switches are 7k and 6k. Thank you. switch# show module Mod Ports Module-Type ...

I want to pair 2 C9500-16X switches using SWV technology. However I don't want to use multiple links for SVL. This will save me two ports. Since almost all interfaces for the downlinks are having dual leg connection, I don't see the issue of keeping ...

Does the Cisco Catalyst 9300 & 9500 series have full Layer 3 Routing Capabilities? Reasons why I question are below:Do these terms mean full routing? "routed access" "Layer 3 forwarding" These terms are used in the data sheet and license details.Data...

I have four 48 port POE 9300's in a stack.  One has a 2x40G QSFP+ module, and another has a 8x10G SFP+ module.  The other two switches have no modules.  Both data and power stacking is used and connected properly.  The ios shows the data stack at 480...

Hi Team. We are trying to stack two new 9300 switches, when we connect switches in stack, we see following message on console, after this we lose the console access and it get stuck at this point.: %RF-5-RF_TERMINAL_STATE: Terminal state reached for ...

Hello,  I just migrate our Edge Switch from Cisco Catalyst 3850 to Cisco Catalyst 9500 (Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.12.02, RELEASE SOFTWARE). My switch has logs every two minutes a terminated ssh connection from the Ip addre...

Currently we are in the process of migrating our legacy 7k/5k/2k environment to VXLAN EVPN.  We have our 7k enviornment connected to two border gateways.  We are connected at layer 2 (VPC) and layer3 (BGP).  We have a desire to move SVI's before we m...