Switching

Hey all   I am having a problem with a 3850-24XS. All traffic stops for 3 pings then returns to normal. Running a constant ping from multiple endpoints on trunk connected switches to multiple ports reveals 3 ping timeouts every 5 - 45 minutes resulti...

Hi All   I have SFP LR type in core(X2-10G-LR) side and access switch side (SFP-10G-LR) but the fiber cable is MM om3.. can work with this case?   Thanks

  Hello,I set up a lab with a switch and a isp routeur connected to it. I can't ping internet from the switch but i can ping the router internal interface (192.168.1.1). set up: SW2960X   -------> ISP routeur ( no access to it, no modification can be...

Hi   Does the 250 Series switches support IP Source Guard feature? I'm looking at the SG250-10P specifically, but I don't see clearly anywhere if the switch has the required feature?

Hi, My English is bad.   I have 3 switches WS-C3850-24T   with sw version   " 03.06.06E0"with license permanet/lifetime of ipbase and lanbase.   I tried use "object-group ACL CLI" but it does not work.   I found this article bug:   https://bst.clouda...

I have C2960X with IOS Version 15.2(2)E6, from the show logging Oct 24 11:54:25.878: %SFF8472-5-THRESHOLD_VIOLATION: Gi1/0/52: Rx power high warning; Operating value:  -2.9 dBm, Threshold value:  -3.0 dBm. what is the advise for this isssue?

Hello experts.   I am trying to connect a Catalyst 3850 to Nexus 9K.   In the main this has been successful, unfortunately whilst the 9K sees the CDP neighbour fine, and can ping the 3850 switch management address I am unable to ping the 3850 from ot...

Hi, currently we have single Layer 3 switch which is also the gateway of all our VLAN's. We're planning to implement a secondary Layer 3 switch with HSRP. My question is can I configure HSRP with a dummy routed port or dummy SVI and configure the HSR...

I just added a Cisco 3850 to an existing Cisco 3850, same model#/SW version: Switch Ports Model              SW Version        SW Image              Mode------ ----- -----              ----------        ----------            ----*    1 56    WS-C3850...

Have a Cisco IE-3000-8TC switch with module IEM-3000-4SM but any FastEthernet ports doesn't works just the two GigabitEthernet ports works, please any help

Hello Community,   since a few hours colleagues of mine and me are discussing how the switching rate of the Catalyst 9400 Chassis is calculated.   In the data sheet it states that "up to 9.2 Tbps" can be reached, but nowhere is explained how this num...