Question, We have recently installed multiple C9407R units in stack-wise virtual that are in production, both unit 1 and unit 2 are in the stack and passing traffic normally. When running a 'show inventory' it does not list all the installed transcei...
Forum Posts
Resolved! Using C9300 as a ntp server
Can use C9300 as a ntp server? Thanks
Hello,As I am studiying for my ENCORE I am using the Cisco e-learning module. There I came across this part of a paragraph:"In the traditional network design, the distribution layer has two standalone switches for resiliency. It is recommended that y...
I'm setting up a network (see image) and the issue I'm having is that I can see the redistributed routes in the routing table of R1 and R5, but I can't ping to them. When I try to ping 2.2.20.2 (R2) from R5 it's doesn't work, I can ping from R4. Sa...
C9300をNTPサーバとして設定することは可能でしょうか。 ※IOS XEのコマンドリファレンスにntp masterの記載が見つからないため。
hi,wich method is better for controling vlans on large LAN? allowed vlan on trunk ports or vlan pruning?
Hello,I manage lot of router and switch my problem is before I do any changes to configuration file I want to save a copy of it if I do sh run using putty it just displays one page worth of information and I have to do copy paste one page at a time i...
1. It's possible to launch into multimode using LRM optics as we have in our Cisco 6500's ?2. what is needed , possibly special launch cable , also what is needed on the HPE J9851A Switch 5412Rzl2 if going to a normal sfp+?
Hi,One of my clients has a Network Challenge, they are pointing fingers to our installed solutions that has been working without issues for months. I got their switches log files, they have 6 switches, 5 of them were throwing mainly this error “%SW_M...
Hi Members, This is happening on my Cisco switch, and I have no idea why this is happening. Anybody had the same issue? If so, how did you all fix this, please? Your help suggestion and idea would be highly appreciated. May 1 23:25:19.000: %LI...
I am using the C9300L-24T-E machine version 17.3 and was wondering what the padding default settings are?
Hi Guys n Gals,I am having a bit of trouble with an assignment I am doing in packet tracer.I don't have the files handy until the eve, so will send pics/files later if required.My problem is that I have an access router connected to 3 separate cluste...
Trying to authenticate I have this error as shown, can anyone help me!*May 11 12:38:20.482: %RADIUS-4-RADIUS_DEAD: RADIUS server 192.168.100.3:1812,18 13 is not responding.*May 11 12:38:20.482: %RADIUS-4-RADIUS_ALIVE: RADIUS server 192.168.100.3:1812...
We have several remote locations with their own L3 switch that we use for routing. Some have direct fiber to our central core others uplink via another router and use VPN to tunnel back to our central office firewall.Edge switches at these locations ...
Hello, I've upgraded my Catalyst to the latest firmware avaliable. But after that the webpage stopped working and I see this Javascript error when trying to see "Port Status" or other pages. Do I need to configure something for this to work? Switch...
