Switching

Hi,I am getting the following error when trying to ping from PC to server can you please help me regarding this"ping request could not find server please check the name" in cisco packet tracker.I am here with providing my file.Thanks in advance.Kavya...

Problem Description:I am encountering an issue with the "set ip default next-hop" command on my n3k-c3064pq-10ge device.Device Information:Model: n3k-c3064pq-10geSoftware:BIOS: version 5.0.0NXOS: version 9.3(13)Configuration Attempt:I am attempting t...

Hello, this is most likely a firewall problem but I wanted to ask here before I go that route.I have 2 locations that are connected with the same fiber run. The primary site has an MX250, and 3 stacks of 2960x switches each with 3-4 switches in the s...

Hello,I'm trying to figure out why Avaya Phones and PC's are showing up as both statically and dynamically learned. We do not have any mac addresses statically configured. Here is the output of a few ports.Cisco9300# show mac address-table int Gi8/0/...

I have Configured the 802.1x Configuration in WS-C2960X-24TS-LL Switch Globally. when i test the aaa test it was successful. but when i tried to configure in the Interface the authentication was not happening. so can you please help to configure the ...

Hey, i am working on a project And I have problems with my DHCP server. I don't remember how it came about. Hence I am asking here. I don't understand why my laptops at the bottom are not getting ip? Anyone who can help me. Packet tracer + Network di...

Hello Bro,I am looking at the rack mount information about 9200CX, but could not find the clearance it may require to dissipate the heat from the switch. Does anybody share if the switches can be stacked tightly one on top of the other?Much appreciat...

hi all,we have a topology without any redundant link. Every access switch is directly connected with the core switch, and it's a port-channel between access switch and the core. RSTP runs on switches by default, and we do not explicitly configure the...

Hi, Do you have been happen this logging show that, and there are none any effect to our netwoek bunisness. im client 'chasfs' has taken 332 msec (runtime: 332 msec) to process a 'stack chasfs fd' messageMar 28 23:25:32.568: %IOSXE_INFRA-6-PROCPATH_C...

Hello, I can't manage to give the connected PCs an ip through the dhcp server. My packet tracer + network design are attached. Have currently only started on the bottom part so it's only about the bottom PCs.Thanks in advance for the effort

On Nexus 7000s I want to limit bandwidth of particular IP. I can do this using proper configuratio of IP ACL, policy map and class map. But what if I dont have information on interface?  Can I apply bandwidth control for particular IP without knowing...