Switching

Hi all, We have a 1710 router with 2 Ethernet ports (1 Ethernet and 1 FastEtherent) and we are configuring one or two vlans, and I am just unsure of myself of the proper configuration1 - When the VLANs are configured do we need or have to have access...

Hi,  I have a working configuration for PBR on a 6500 running 12.2.33SXH8b. PBR is applied to an SVI interface. Like I said, PBR works exactly as I want it to. The thing is when I start adding more traffic to the PBR (only 3 route-map classes) at som...

I have a network where I have created 4 different VLAN's.  One VLAN for phones which is tagged and then several other VLAN's that are untagged.  I would like to route these together using a CISCO layer 3 switch.  I have tried doing this but when rout...

Hi all, I have to configre hsrp authentication in a 7700 series, I do the following command. interface vlan 10hsrp 0 ipv4authentication md5  key-chain   Set key chain key-string  Set key string Which one should I use to encrytp my password? thanks. 

Hi all, I have one MDS 9700 and 3 9148,  how can I connect this 3 9148 to my MDS and how can I connect the 3 devices between them? thanks. 

I purchased a Nexus 3172PQ online secondhand and when I received the switch the admin module (the module with the two rj45 ports and the usb) on the right rear of the switch was missing. I contacted my seller and they said they would send one to me o...

Data transferring speed is clearly much faster in connecting to GE1/0/45 than GE3/0/25.Pls advise me why becoming faster if you know it. Port interfaces Information is very limited as follows. interface GigabitEthernet1/0/45 switchport access vlan 13...

Would I need to do it on EVERY other switch that I want knowing about those Vlans? I wouldn't think I do since I plan on TRUNKING between all those Switches anyway. And I use VTP between all my Switches. I almost think I don't need that command at al...

HowdyWe added Site02 for redundancy and DR. Also added new SAN and ESX hosts.The CPU on device Site01Server01 is not very happy when files are being transferred between the sites. Since the setup is the same at both sites, why is the problem only at ...