Please someone help me deschiper the QOS on our legacy distribution switches, these are the switch connecting to our closets, each port is a fiber trunk back to the distribution. I'm assuming this is the egress queue, I have some understanding of wha...
I have a router that uses OSPF to determine routes to a central location. This same router also has a static route with a higher administrative distance on it, pointed to a backup router.ip route 172.25.19.0 255.255.255.0 192.168.105.2 250in case the...
Scenario;I have a subnet, 192.168.1.0/23, with clients. I'm using the switch as dhcp-server. I want to route the first /24 subnet to one gateway, and the second /24 subnet to another gateway;!interface Vlan666ip vrf forwarding gjestip address 192.168...
I've been troubleshooting a network for a while where the problem appears to be MAC address table filling up. My customer has two ME3400G-12CS-A switches on two sites connected over a WAN link with local subnets routed between each site. Site 1 acts ...
Hi!Lost on this one. SVI L3 interface configured with inbound and outbound ACLs. On inbound ICMP ACL, ICMP packets are logged from a source that doesn't belong to the subnet that is being controlled! Anyone know what's happening? Thanks in advance!Fe...
is it possible to connect a WS-C4948 switch to a Nexus 5010? I have a flat network with no vlans.I know you are suppose to use the first 8 ports of the Nexus to get it to be on a 1GB port. What gbic am i to use on the ws-c4948 switch? if using a fibe...
Hello,We are using the following port-security configuration on user access ports on Cisco 2960 switches, in order to protect the infrastructure to prevent MAC flooding attacks: switchport port-security maximum 10 switchport port-security switchport ...
Hi all,first all, sorry about my english. I hope you could understand me I have been reading all the day different documents and discussions on this forum...but something is still wrong .I have two 4500 working on HSRP. I have a FTP server on vlan 6 ...
Hi All,I am really curious to investigate a possible reason behind this error message.During the configuration of a port channel bundled with 2 links I have the error in the subject but only for one side of the connection and only for one link part o...
I have a 10/100 POE managed switch laying around that I wanted to rack up to use for my VoIP phones. I however, had since lost the mounts (or never had them to begin with). I've been looking all darn day for mounts just for this. It doesn't seem to f...
Hi all,we are dual homing with another AS and we have BGP routes being redistributed in to OSPF...am I right in thinking that when looking at the type 5 LSA's for a particular prefix, I should see two of them? One type 5 LSA from each ASBR? How can I...
Hello all,I need some direction. I have had several people look at our setup in regards to QOS and have had several Cisco TAC cases opened about it as well and we still have issues during the video stream at the remote locations where the video will ...
Hi Everyone,if sh ip route showsGateway of last resort is 172.24.250.3 to network 0.0.0.0S* 0.0.0.0/0 [1/0] via 172.24.250.3S 172.16.0.0/12 [1/0] via 172.24.250.1We need to see destination IP subnet 172.24.150.x uses which IP as next hop need ...
Hi all,Bit of a strange problem reared its head today.Trying to copy the startup config to a remote tftp server is not working when copying from my 3750G switch, all other switch config transfers are ok.ACL has been configured on an inbound routed in...
