Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hello,I am trying to redirect packets to a bluecoat proxy sg using WCCP on a 3750x stack with IP services.I cant get the packets to redirect.The bluecoat device is on the same vlan as the client traffic that I am trying to redirect.It seems that when...

Support CommunityWe recently configured a stack of four 48 port 3750-x switches . We are noticing high CPU usage. "Hulc LED process" seems pretty high.This has coincided with VMware servers getting slow and non-responsive at times, perhaps a coincide...

johnramz by Level 1
  • 58353 Views
  • 37 replies
  • 0 Helpful votes

Hello, we have a 2911 router, connected directly to our ISP. Our ISP grants us 5 public IP addresses in a 255.255.255.248 subnet, from IP 217.xxx.xxx.250 to 217.xxx.xxx.254.Gateway to internet is 217.xxx.xxx.249My idea was that the router, through gi...

Dear all:          My configuration:                               radius-server host 10.138.44.57 auth-port 1645 acct-port 1646 key 7 ******                !                aaa new-model                !                aaa authentication dot1x defau...

canalc by Level 1
  • 2989 Views
  • 3 replies
  • 0 Helpful votes

Resolved! span port channel

Hi All,   Is there any option to span port channel of Cisco 6500 Switch.If possible What is the configuration for the same..Pls help..Regards,Ajith

HelloI have the following scenary500 Mb/s Internet Bandwhit20 Aplication Servers (1 GB2400 Public internet connection to my network (maximun values)400 Staff PCIP services (L3) how  can I calculate the throughput needed in my core switch? if did serv...

cbyters13 by Level 1
  • 995 Views
  • 0 replies
  • 0 Helpful votes

I cannot figure out how to NAT the destination field in the IP Packet. I have tried a few different things. We have a server that needs to connect over a VPN to an IP that we currently have in-use. I have chosen the 192.168.13.x /24 network to use fo...

bunjiega by Level 1
  • 1310 Views
  • 4 replies
  • 0 Helpful votes

Hello,Im trying to setup access for our guests to go out a specific interface/ISPWe have our main connection to our datacenter.We also have a little SAT Receiver that we get internet from (10MB).I want a specific vlan to go out ONLY to that SAT Recei...

Hi All,I am currently in a position of consolidating our backup solution between two seperate infrastructures, basically consolidate one infrastructure to use another. At the moment both infrastructures sit within the same Data Centre and racks are c...

Jazz80813 by Level 1
  • 631 Views
  • 1 replies
  • 0 Helpful votes

Hello,I am having troubles to configure PRIVATE VLANs on Cisco ME 4900. The scenario is as follows:We need to connect several DSLAMs on the 4900 switch, every DSLAM has 4 VLANs configured (VOIP service, MGMT, ADSL Private, ADSL Public), and sends the...

Arber_123 by Level 1
  • 2134 Views
  • 2 replies
  • 0 Helpful votes

Bonjour à tous, j'ai une question concernant la procédure à suivre pour mettre en place un switch  (et créer laba un vlan wifi) conecté à un linksys wireless router puis à la fin un utilisateur wifi (laptop ) + des utilisateurs fixe avec cable conect...

fer_douce by Level 1
  • 3660 Views
  • 0 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card