Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

I have a router and a switch that many of the commands dont seem to work on, or must be modified to work. I am not sure if there is a newer version of the ios that would make these commands work or if my router and switch would even support them. I h...

breynold76 by Level 1
  • 1114 Views
  • 10 replies
  • 0 Helpful votes

Ciao a tutti,vorrei cortesemente sapere se un fault dell'active BSR router verso lo standby comporta una qualche riconvergenza/ricalcolo dell'albero mcast.Oppure se il BSR discovery ed election verso un altro router comporta un evento di fault sul fo...

rsolaro by Level 1
  • 280 Views
  • 1 replies
  • 0 Helpful votes

Resolved! OSPF & IPv6

I'm running a 3750-X with the IP Services feature set and IOS 15.0(2)I've setup IPv4 routing with OSPF, using the config:router ospf 1234  network 1.2.3.0 0.0.0.255 area 0.0.0.0  ...I then added IPv6:ipv6 router ospf 2048interface vlan500  ipv6 addre...

Resolved! switch HA

Currently i have cisco 3560 switch acting as core switch for some very important business application and it is single point of failure. I am considering getting single or a par of switches that have HA support so in case one switch dies other switch...

Damir Reic by Level 1
  • 1401 Views
  • 14 replies
  • 0 Helpful votes

Hi, my router is hit by Fake traffic from IP 10.10.101.33i can see it in my accounting packets.10.10.101.33 doesnt exist in my LAN, its not a valid IP.sh ip route 10.10.101.33% Subnet not in table Default route goes to Cisco ASA.How can i find out MA...

Resolved! CISCO POE

Hi All - Is that possible to make use of unused power in cisco Switches?Lets say a switch Which has 5 Port POE with 15.4 watts out of which 4 device requires only 5.4 Watts and the 5th device requires more than 15.4 W at this time swich can support t...

                   Hello,I am looking for any assistance with an issue I am having.  Within my network, I have two NetApp enclaves that replicate with each other.  These hang off of separate switches, one at our primary site and one off of our second...

Hi everybodyI just passed my CCNP tshoot exam on 2nd attempt.  It took me 1.5 years to get it (  My job is quite different, I work with electronics so what I do at work and what i do at home( studying for CCNP) is different)I want to thanks Peter Pal...

sarahr202 by Level 5
  • 772 Views
  • 14 replies
  • 0 Helpful votes

Hi guys,This is my first time configuring VLAN on Cisco switch.My main purpose of configuring VLAN is to break broadcast domain inside a switch into 2 separate VLAN. I have created the 2 VLAN and assign the port to it. However I don't know how to rem...

Hey - I want to enable some real QoS at a new site as opposed to auto-qos. The site is going to have a 1002 router and 2, 3750X switches. The phone are going to be Nortel. I'm thinking of enabling VLAN-based QoS. I'm referring to a Nortel document fo...