Switching

Hi, I am running IOS  c7200-p-mz.123-20.bin and want to hard set bandwidth on an interface to 10 MB. Is it possible to do to this using the rate-limit command? If so, how?  If not how can I achieve this?rate-limit input 10000000 X X conform-action tr...

I have read many sheets on the 3560, we currently use them. We do have a situation where we need Fault-Tolerance built into our environment. I have looked into the cluster feature of the 3560 but it would seem that is for management only. I see the 3...

Hi all,I've been searching for information regarding the CGR 1120 Router and haven't been able to determine if the router supports HSRP.Is it possible to find out if this router supports the Hot Standby Routing Protocol?Thanks

HelloHow to secure router and switch on remote location so that password / config is not taken using pa$$word Recovery option.Switch 2960 and router 2900 seriesthanksST

hello everyone.please help me understand if i am making  a mistake. please refer to the follwoing configs.  I am trying to filter out LSA type 5 from entering into area 2. Although area 2 is a stub area, i still see an E 2 route in its table. So R8 i...

With the Nexus 7K supporting FEX and the 2K.  How are the 2K ports allocated to VDCs?  My assumption is that the limitation is still the hardware on the 7K and that the FEX port(s) would need to be assigned to a particular VDC, which would assign the...

Hi all,on some of our ports on Nexu 5000 and on the connected FEX we can see a lot of Jumbo Packets though there is not enableed any JumboFrame on the Switch, all Interface and system MTU is set to 1500.Any idea what the reason could be ?DBE-LINZ-XX4...

Hello,I've never had a router's CPU suddenly hit 99% and just stay like it for hours even after a reboot.  This router really does nothing with regards to CPU, I'm looking at it's CPU history (via SolarWinds Orion NPM software that we use) and it is ...

I have a connection problem. I can't access my remote router, it says that it is 'half-duplex.' In assuming it needs to be 'full duplex,' how can I change this?Thank you in advance,AR

HiI want to know how does cisco detect OQD detection on one interface ? Does Cisco use particular protocol for overflow detection on output queues?for example sening some special packet on wire to another peer.Thanks in advance

Hi I have two 3750x in a stack  running c3750e-universalk9-mz.122-55.SE3.bin with License Level: ipservicesI am planning to upgrade to c3750e-universalk9-mz.122-58.SE2.bin will this keep my ipservices licence or revert back to IPbaseThank you for any...

we're still in the testing phase of the VSS system.what we notice is that if we disable the link between the active/standby chassis (by pulling the fibers), and connect them back in, it requires a complete chassis reboot of the standby. is this norma...