Switching

 HelloI have a here 9300-48P that has two 715W power supplies installed, but withthe command "sh power inline" it doesn't show the total power calculated?both LEDs light on the supply's backside are shining green and correctlyS9300-12345# sh env powe...

Hi, I read somewhere that the IEEE recommended size of a broadcast domain in an enterprise network application is /22, however I cannot find that particular document when searching around. Can someone please share the link to the said document if som...

Hi All, i need some help in understanding what is the difference between RootID and Bridge Id.I know bridge id is priority.mac add and that it elects the root bridge and determine which switch is gonna have is link blocked. but what is this root ID??...

I've come across this "no ip redirects" command while labbing, this came up while learning how to configure HSRP.  The Cisco page on HSRP speciifies this command as part of their config.  Iv been doing to research on this and I think I have the basic...

Hi. I expand my network with a SG110D-05: from router to the switch and from switch two cables, one to tv and the second one to wlan-extender. I noticed that the connection on the tv breaks off sporadically - usually only 1-2 seconds.I pinged through...

Hello Team,I have done the IOS upgrade by using the below command in the Cisco WS-C3650-24PS  platform. #request platform software package install switch all file flash:cat3k_caa-universalk9.16.12.07.SPA.bin The switch come up with the expected IOS v...

Hi everyone, I am having trouble with an assignment my instructor have given me. In this assignment i have to configure different things: VLAN, Inter-VLAN routing, OSPF, NAT etc. Right now i have setup VLANs, trunks, etherchannels, RSTP, Portfast & B...

Hi, is it possible to have 2 core switches running with the very same SVIs configured? Im not referring to stacking. I want to take down the old core later on but will gradually transfer the connected devices from old to the new core one at a time.