Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi all,I have a sorta silly question here. I just got a 3750 and all of the ports say they're part of FastEthernet3. So to check port 48, I would type:sh int fa3/0/48I was expecting to have it be FastEthernet0.I figure this is because of the Stacking...

tabiv by Level 1
  • 5970 Views
  • 4 replies
  • 0 Helpful votes

Hi,We have an ASA 5505 with the base license (10 users), we recently bought an upgrade license for it for 50 users but when we try to activate it says we need a service contract for this, Is this correct? I've searched for info regarding to this but ...

Resolved! Router upgrade

                   Cisco 2811 Router is installed currently with c2800nm-advipservicesk9-mz.124-15.T.bin IOS image. We are planning to upgrade the IOS.Should I upgrade with "c2800nm-advipservicesk9-mz.151-4.M4.bin" OR "2800nm-advipservicesk9-mz.151-3...

                 We have confirmed all internal traffic trying to access the internet getting to the Cisco 3750 stack but nothing leaving going through external interface to the internet.We have an MPLS router with external interface configured with ...

pain112 by Level 1
  • 1500 Views
  • 8 replies
  • 0 Helpful votes

Hello,What type of twinaxial 10GB is the rigth cable if I want connect two catalyst supervisors (two 4500/6500) with 10GB uplinks?.Do I need use active or passive ?.Is enougth with the SFP+Twinax cable like SFP-H10GB-xxx ? or do I need an aditional p...

Hi Guys,I am recieving the following error messages for one of the interfaces connected on N5K switch which went down.I did a shutdown and no shut and everyting was back to normal , however I would like to know the root cause of such a problem and ho...

Dears ,i have the following configurations for QOS in my 3750 switch & i need to understand these configurations in details as i`m not experienced in QOS configurationsmls qos map cos-dscp 0 8 16 26 32 46 48 56 mls qos srr-queue input bandwidth 90 10...

Hi there,I am searching for a Cisco switch that provide layer 3  features for a local network. Currently i use a 3560 8 ports model and I need something with the same characteristics but having all ports as Gigabit ports.Thanks for helping !Cheers !

HiI am trying to assign the voice vlan without configuring directly in the interface,     switchport voice vlan id. I have been looking into some possible solutions:      Radius      Smart Ports events      VMPSThe final goal: A phone connects to an ...

ssfreques by Level 1
  • 1973 Views
  • 0 replies
  • 0 Helpful votes

hi guys,need some help here. my situation is a bit complicated.1. i have a few sites which are interconnected.2. there are multiple mobile sets of equipment(servers and catalyst 3560 switch) which i need to connect at different sites. (i cant use rep...

cashqoo by Level 1
  • 690 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card