Switching

Hello,I have purchased these two switches from ebay as a test lab, I plan to connect them up via a gigastack module\cable and enable ip routing on the c3550 and vlans to talk to each other.I'm very much a procurve person and really need to get into t...

I am looking for recommendations on the hardware necessary to establish a hybrid in house lan.  I am building a new house and have wired each room with cat5 to a central point in the attic, paired with this is the tv cable and phone wire.  I would li...

I have 2 6504's running HSRP as my core.  They are each etherchannel'd to my Datacenter switch (3750 Stack) -- see image below.The problem i a having is with the etherchannel status:Core1 PO11 status w (waiting)Core2 PO11 status P(bundled) DC11 PO48 ...

Hello Everyone,Its me again, back with another cornerstone case from the real world. I have a customer who wants to connect his servers into a 6509 VSS pair using HP's NIC teaming software. The thing is, he doesn't want to create LACP port-channels t...

Hi,We've implemented port security on our switches and we configured them to alert us when the ports are violated. If we set them to shut with the violation, it just alerts us once but, if we set them to restrict it will continuosly alert us untill i...

Hi ,I'am doing a core swith migration 4506. I need to find out the servers attached to my core switch,the problem is some time I'am getting the ip address and some time ip address is not comming, I'am doing this with this command,Switch # sh mac-addr...

Hi all,I am trying to configure 'HWIC-3G-HSPA-G' card in a 1921 router, using a UK Vodafone SIM card. I have a client connected to the GE 0/0 interface and I am trying to access the web from that client. Connected to the console port on the 1921 I ca...

I have recently configured a cisco 1921 router for internal routing on my network.  Here is what i am trying to accomplish:Main network 10.65.1.0   mask 255.255.255.0- all office devies and computers.Second network 10.65.2.0  mask 255.255.255.0 - All...

I have been trying to get my Cisco 881 to allow internet access to my clients via a Dlink DSL modem, but I can't seem to get the pppoe connection to work through the router. I have tried configuring the WAN link as the pppoe client, but I don't think...

I'm looking for more information on Cisco Catalyst 3560-e POE and 3560-x documentation. Please advise what is the best way to start with these models.

As a test I have enabled a policy-map PM-QOS-LAN on my switch VLAN 'LAN' interface to match packets based on ACL, and set DSCP EF.  I can see matches for this policy-map.  However when I enable another policy-map PM-QOS-WAN on my switch VLAN 'WAN' in...

Recently we implemented VRF-Lite I our struture.In that job we also implemented RouteLeaking Between Coustumer VRFs, and our VRF(where we provide some services as Backup, Monitoring, NFS/iSCSI), etc, etc, etc...We control those route-leaking with rou...

Hi,The sup-2T has 3 1G uplink ports and 2 10G uplink ports.Can the 5 ports be in using at the same time?Thanks.