Switching

Hi,I thought i would post here as I know people reply and get good answers!Its HP ProCurve related.............I have a 5406zl and a 2510G, from the 2510G I  have 2x 1Gb Copper Links connecting to the core, I want to create a  trunk + lacp with these...

Any reason why an old 3508 and our new 3750 would not be able to connect via trunk port?  We have verified the Gbics and Fiber cables are good, but the interfaces will not come up. Both sides are set to trunk, dot1q....that's it.  Anything we are mis...

I'm seeing some odd behaviour out of a trunk between my 6509 (running Version 12.2(33)SXI) and a VMWare host. We are trunking between the two devices. Here's the switch configs:interface GigabitEthernet2/2/20description VMUNC001 NIC 2switchportswitch...

HiI'm have to install and removing module in our old C6506 switch chassis.  Actually CatOs is running on these systemhere show version output commandWS-C6506 Software, Version NmpSW: 5.5(19)Copyright (c) 1995-2003 by Cisco SystemsNMP S/W compiled on ...

Dear Sir,Follow the attach file.Now, I want to run VSS function, but the edge switch two uplink across two ISP link!Could I setup the etherchannel:1) VSS & Edge Switch Etherchannel mode ON.2) Etherchannel load-balance mode:    VSS --> dat-ip-mac    E...

Hi All,   Any input is appreciated.  We hav a very simple setup:2811 Router <-> 3750 ( with 2 vlans ) <-> Vlan 1 PCs & Vlan 2 PCsWe are running eigrp on the two. There is a default route on the 3750 to the 2811. Vlan 1 PCs can ping out to the interne...

I have two 1841 routers that are connected over a dedicated T1 line. I would like to be able to extend the vlan information on one network to the other. So basically I would like to be able to use a trunk link over the T1. Is this possible? Switch--...

New to nexus and I'm trying to figure out how to set up queuing on the 5k.I'd like to trust cos which I think the 5k does by default. I would then like to put cos 5 (voice) in a priority queue and so on.From my reading I think the 5k has 6 queues?Doe...

Hello all,We currently have a cisco 1811 router that is connected to one isp (verizon). This is also configured as our DHCP server. Latley verizon has been causing us issues on their end, and i was wondering if it is posible to set up a 2nd network c...

Does any one have the document that explains how to load an IOS on a 3925 router that doesn't have one on it?

Hi All,Is there a Vwic module that will support unframed traffic on a T1 line that will work with a 2811 routerthis is driving me mad, please help me before i lose the will to live

Hi,i've one issue...the distance between the switch and the equipment is more than 300 fts but we cat5 cable we can't go more than 300 ft. pls advise what other options are available...