Switching

Hello all...  Here is my issue:I am trying to connect two WAP4410N Wireless-N Access Points to a WRVS4400N Wireless-N Gigabit Security Router.I have the following configured on the router:                B/G/N-Mixed                Channel 6          ...

Dear All,I have one query.If I will connect 3 nos of switch in triagle pattern.A -------B|        /|      /|   /CNow All the switches have configured with Spaaning-Tree LoopGuard Default. Means Loopguard is enable on all the ports.Will it work or if ...

HiI have a 3750G-12S with SFP modules GLC-GE-100FX=.Interfaces work fine, but I noted an unusual overheating of SFP modules.I don't know the exact temperature, but to give you an idea, when I remove an SFP module from the slot I difficultly can take...

how to clear the counters of the "sh platform port-asic stats drop g1/0/28" on C3750C3750#sh platform port-asic stats drop g1/0/28  Interface Gi1/0/28 TxQueue Drop Statistics    Queue 0      Weight 0 Frames 0      Weight 1 Frames 0      Weight 2 Fram...

Dear friends,A 6500 having a redundant sup setup (SUP 720-3B) and platform being 6513 with 12.2(33)SXI3 Advanced IP Services.The 6513 does not recognize the standby supervisor's compact flash memory.The supervisor is equipped with CF adapter which in...

Hello, I'm trying to configura simple VLAN in packet Tracer, In my company we have a rooter 2811 and a switch 2960 Catalyst 48TT.In the packet tracer I use 2811 and 2960 24 TT and 2 PC's, I try to configure 2 vlan's vlan 10 use the port 5 in wtich is...

Guys,I have an HSRP setup on two 3560 L2 switches (thanks to your guys help).I am trying to figure out the best way to get the back to the firewall on the standby router.My guess is to make a 2nd interface on my sonicwall firewall ( i know trying to ...

hi everybodyI 'm lookin' for CiscoWorks network management software or equivalent on support section on cisco website support.I want it to configure snmp on my catalyst 2950 and get some results likes input and output traffic rate on my catalyst, all...

I have 3750 switch and connected to my all edge switches through fibre cable.  I want to know that the link between 3750 and edge switch 2960 is gigabit link, how i can check that gigabit link is ok.i was check some cisco command its shows speed=aut...

Hi,I am trying to understand the QOS toolsets and applying them in different scenarios.Scenario 1:  There are multiple inputs into a switch for eg: 8 x 100Mb ports and only 1 x 1Gb uplink port out of that switch1. Is there be any benefit in using QOS...